C13, C15, and C18 Tier 4 Final Engines Caterpillar


Electric Starting Motor

Usage:

826K 232


图 1g03365178

表 1
352-9767 电起动马达总成的技术规格 
项目  数量  零件  技术规格说明 
小齿轮和壳体之间的间隙为 9.1 mm (0.36 in)。 
4B-2049 螺母  接地终端。
拧紧至扭矩为 3.4 ± 1.2 N·m (30.1 ± 10.6 lb in)。 
4B-2049 螺母  开关接线端。
开关端子必须用热收缩管绝缘。 不要使用模压端子。
拧紧至扭矩为 3.4 ± 1.2 N·m (30.1 ± 10.6 lb in)。 
6V-8188 螺母  接地终端。
拧紧至扭矩为 30.5 ± 3.5 N·m (269.9 ± 31.0 lb in)。 
6V-8188 螺母  马达终端。
拧紧至扭矩为 30.5 ± 3.5 N·m (269.9 ± 31.0 lb in)。 
6V-8188 螺母  蓄电池终端。
蓄电池端子螺母最多可使用三条电缆或导线端子。 两个电缆接线端可以等于或高于 0 AWG。
拧紧至扭矩为 30.5 ± 3.5 N·m (269.9 ± 31.0 lb in)。 
6V-8188 螺母  马达机架终端。
拧紧至扭矩为 30.5 ± 3.5 N·m (269.9 ± 31.0 lb in)。 
20 V 和 25° C (77° F) 时的吸合电流为 49.3 ± 3.3 安培。 
20 V 和 25° C (77° F) 时的保持电流最大为 6.8 安培。
当从小齿轮端观看电起动马达时,马达顺时针旋转。 
25 °C (77 °F) 时无负载: 
转速为 6950 ± 1650 rpm。
电流消耗 115 ± 25 安培。
电压为 23 VDC。

Caterpillar Information System:

C13, C15, and C18 Tier 4 Final Engines Cylinder Head Valves
C13, C15, and C18 Tier 4 Final Engines Electric Starting Motor
C13, C15, and C18 Tier 4 Final Engines Housing (Front)
Failure of the Electronic Thermostat (ESTAT) on C175-16 Generator Set, Marine, and Petroleum Engines{135V} Failure of the Electronic Thermostat (ESTAT) on C175-16 Generator Set, Marine, and Petroleum Engines{135V}
C9.3 Engines for Caterpillar Built Machines Diesel Exhaust Fluid Module - Assemble
C9.3 Engines for Caterpillar Built Machines Diesel Exhaust Fluid Module - Disassemble
Cat® Detect Object Detection Hardware Generation 4 for Small Off Highway Trucks, Motor Graders, Large Wheel Loaders, Large Wheel Dozers and Articulated Trucks Maintenance Interval Schedule
Cat® Detect Object Detection Hardware Generation 4 for Small Off Highway Trucks, Motor Graders, Large Wheel Loaders, Large Wheel Dozers and Articulated Trucks Washing System - Check
Cat® Detect Object Detection Hardware Generation 4 for Small Off Highway Trucks, Motor Graders, Large Wheel Loaders, Large Wheel Dozers and Articulated Trucks Object Detection Sensor - Inspect/Adjust
Cat® Detect Object Detection Hardware Generation 4 for Small Off Highway Trucks, Motor Graders, Large Wheel Loaders, Large Wheel Dozers and Articulated Trucks Object Detection Sensor - Clean/Inspect
Cat® Detect Object Detection Hardware Generation 4 for Small Off Highway Trucks, Motor Graders, Large Wheel Loaders, Large Wheel Dozers and Articulated Trucks Camera - Inspect/Adjust
Cat® Detect Object Detection Hardware Generation 4 for Small Off Highway Trucks, Motor Graders, Large Wheel Loaders, Large Wheel Dozers and Articulated Trucks Camera - Clean
2013/05/10 A New Water Seal Assembly Is Now Used on All 3408 and 3412 Engines {1100, 7555}
C9.3 Tier 4 Final Engines Cylinder Head Valves
G3512H and G3516H Generator Set Engines Engine Oil Filter Housing - Disassemble
G3512H and G3516H Generator Set Engines Engine Oil Filter Housing - Assemble
C9.3 Industrial Engine Engine Control Module - Remove and Install
G3512H and G3516H Generator Set Engines Engine Oil Pan - Remove and Install
G3512H and G3516H Generator Set Engines Engine Oil Pan - Disassemble
C13, C15, and C18 Tier 4 Final Engines Flywheel
C15 and C18 Industrial Engines Flywheel Housing
C9.3 Tier 4 Final Engines Flywheel
C9.3 Tier 4 Final Engines Flywheel
C9.3 Tier 4 Final Engines Flywheel
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.