External Source Sync Relay and Terminal Block
Show/hide table
Illustration 1 | g01271152 |
ESS Relay and Terminal Block |
The optional external source SYNC (ESS) relay (K6) and the terminal block are located on the right panel of the I/O cabinet. The terminal block provides a location in order to wire the external source that is being synced.
Refer to Systems Operation, Testing and Adjusting, UENR3954, "Internal Component Preremoval Steps (Input/Output Cabinet)" in order to shut down the system and gain access to internal components.
- Loosen the wire screws that attach the wires to the terminal block. Disconnect the wires that lead to the terminal block and from the terminal block. Verify the labeling on the wires with the location of the wire. Verify the labels on the cables.
- Remove the two screws that secure the relay and the terminal block to the right panel.
- Secure the relay and secure the terminal block to the rail.
- Attach the relay and the terminal block to the left panel with the two screws. Refer to Illustration 1.
Show/hide table
Illustration 2 g01271277 - Attach the wires to the terminal block. Verify the labeling of the wires with the location of the wires. Refer to Illustration 2.
Caterpillar Information System:
C7.1 Engines Pistons and Connecting Rods - Remove
C7.1 Engines Pistons and Connecting Rods - Install
C7.1 Engines Pistons and Connecting Rods - Disassemble
C7.1 Engines Pistons and Connecting Rods - Assemble
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Fan (Input/Output Cabinet)
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Isolation Switches
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Fan Transformer
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies System Fuse (Input/Output Cabinet)
C7.1 Engines Piston Cooling Jets - Remove and Install
C7.1 Engines Lifter Group - Remove and Install
C3.3B Tier 4 Final Engines for Caterpillar Built Machines Fuel Injector
C7.1 Engines Inlet Manifold - Remove and Install
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Gen Set Module Circuit Breaker (Input/Output Cabinet)
C7.1 Engines Rear Power Take-Off (RPTO) - Install
C7.1 Engines Rear Power Take-Off (RPTO) - Remove
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies General Information (MMS System Cabinet)
C7.1 Engines Refrigerant Compressor - Remove and Install
C7.1 Engines Relief Valve (Fuel) - Remove and Install
C7.1 Engines Rocker Shaft - Assemble
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Internal Component Preremoval Steps (MMS System Cabinet)
C7.1 Engines Rocker Shaft - Disassemble
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies System Fuses (MMS System Cabinet)
C7.1 Engines Rocker Shaft and Pushrod - Install
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Front Panel Display (MMS System Cabinet)