Central Lubrication System - Lubricate - If Equipped
Show/hide table
 |
|
挤压危险。 进入铰接区之前应确保发动机起动开关处于 断开（OFF） 位置并接合停车制动器。 否则会导致严重的人身伤亡。 |
Show/hide table
| 注意 |
|---|
|
检查至所有远置黄油嘴的管路是否损坏。 如果润滑脂管路裂开，润滑脂就不能到达需要润滑的零部件。 造成机器损坏。 |
加注润滑剂之前，先把加油嘴擦净。
油嘴位于机器铰接区左侧。
- 通过远置油嘴 (1) 向左后提升臂的轴承加注润滑剂。
- 通过远置油嘴 (2) 向右后提升臂轴承加注润滑剂。
- 通过远置油嘴 (3) 向右提升油缸盖端的轴承加注润滑剂。
- 通过远置油嘴 (4) 向左提升油缸盖端的轴承加注润滑剂。
- 通过远置油嘴 (5) 向左提升油缸杆端的轴承加注润滑剂。
- 通过远置油嘴 (6) 向右提升油缸杆端的轴承加注润滑剂。
- 通过远置油嘴 (7) 向左铲斗枢轴轴承加注润滑剂。
- 通过远置油嘴 (8) 向右铲斗枢轴轴承加注润滑剂。
Show/hide table
图 3 g02790817 - 通过远置油嘴 (9) 向倾斜连杆机构铲斗端的轴承加注润滑剂。
- 通过远置油嘴 (10) 向倾斜杆中央枢轴轴承加注润滑剂。
- 通过远置油嘴 (11) 向倾斜油缸杆端的轴承加注润滑剂。
- 通过远置油嘴 (12) 向倾斜连杆机构的倾斜杆端的轴承加注润滑剂。
- 通过远置油嘴 (13) 向倾斜油缸盖端的轴承加注润滑剂。
- 通过远置油嘴 (14) 向左转向油缸杆端的轴承加注润滑剂。
- 通过远置油嘴 (15) 向右转向油缸杆端的轴承加注润滑剂。
Show/hide table
| |
| 图 1 | g02761945 |
Show/hide table
| |
| 图 2 | g02790812 |
Caterpillar Information System:
299D and 299D XHP Compact Track Loaders and 272D and 272D XHP Skid Steer Loaders Machine Electronic Control System Features
Machine Preheater for Track Feller Bunchers Machine Preparation for Troubleshooting
521B and 522B Track Feller Bunchers Alternate Exit
773G and 775G OFF-Highway Trucks Engine Supplement Hood - Remove and Install
299D and 299D XHP Compact Track Loaders and 272D and 272D XHP Skid Steer Loaders Machine Electronic Control System General Information
521B and 522B Track Feller Bunchers Daily Inspection
C27 and C32 Engines for Caterpillar Built Machines Housing (Rear) - Remove and Install
2011/11/02 Coolant Additive is Now used on Certain Motor Graders {1352, 1395}
259D, 279D, 289D, 299D, 299D XHP, 299D2 and 299D2 XHP Compact Track Loaders, 257D, 277D, 287D, 297D, 297D XHP, 297D2 and 297D2 XHP Multi Terrain Loaders and 236D, 242D, 246D, 262D, 272D, 272D XHP, 272D2 and 272D2 XHP Skid Steer Loaders Piston Pump (Work Tool) - High Flow
521B and 522B Track Feller Bunchers Machine Systems Swing Motor Relief Valve Pressure - Test and Adjust
793F CMD Off-Highway Truck/Tractor Braking System MID 116 - CID 0168 - FMI 04
C27 and C32 Engines for Caterpillar Built Machines Housing (Front) - Remove and Install
R3000H Load Haul Dump Circuit Breakers - Reset
R3000H Load Haul Dump Collet Pin Bolt Torque - Check
R3000H Load Haul Dump Cooling System Coolant Extender (ELC) - Add
R3000H Load Haul Dump Cooling System Coolant Level - Check
R3000H Load Haul Dump Cooling System Coolant (ELC) - Change
R3000H Load Haul Dump Cooling System Coolant Sample (Level 1) - Obtain
R3000H Load Haul Dump Cooling System Coolant Sample (Level 2) - Obtain
R3000H Load Haul Dump Cooling System Pressure Cap - Clean/Replace
R3000H Load Haul Dump Cooling System Water Temperature Regulator - Replace
R3000H Load Haul Dump Crankshaft Vibration Damper - Inspect
980M and 982M Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Solenoid Valve (Ripper)
® for Dozing, Semi-Autonomous Tractor System (SATS) Camera - Clean