Flywheel Housing
Show/hide table
Illustration 1 | g02697978 |
Show/hide table
Specification for 344-2902 Flywheel Housing Gp | |||
Item | Qty | Part | Specification Description |
Apply blue Loctite high flex GM on the gasket surface of the flywheel housing. Assemble the flywheel housing to the cylinder block and tighten within 10 minutes of applying the sealant. | |||
- | 14 | 6V-8197 Bolt | Tighten the bolt 1 through bolt 14 in the numerical sequence as shown in the Illustration 1 to standard torque.. |
Caterpillar Information System:
CG137-08 and CG137-12 Generator Sets Flywheel
CG137-08 and CG137-12 Generator Sets Stub Shaft (Rear)
G3516 Engines Engine Speed Sensor
G3516 Engines Engine Speed/Timing Sensor
C13, C15, and C18 Tier 4 Final Engines Speed/Timing Sensor
C15 Engines for Combat and Tactical Vehicles Air Inlet and Exhaust System
CG137-08 and CG137-12 Engines Flywheel Housing - Remove and Install
C4.4 Marine Generator Set Engine Operation
CG137-08 and CG137-12 Engines Flywheel - Remove and Install
CG137-08 and CG137-12 Engines Vibration Damper and Pulley - Remove and Install
CG137-08 and CG137-12 Generator Sets Valve Cover
C280 Marine Engines Nitrogen Oxide Sensor (Exhaust Pipe Out)
C13, C15, and C18 Tier 4 Final Engines Pressure Sensor (Exhaust Differential)
3516C Generator Set Engines Catalytic Converter Sensor
C13, C15, and C18 Tier 4 Final Engines Front Housing and Covers
3516C Generator Sets Glossary
3516C Generator Sets Engine Crankcase Breather - Clean
C15 Engines for Combat and Tactical Vehicles Lubrication System
C4.4 Marine Generator Set Before Starting Engine
CG137-08 and CG137-12 Engines Crankshaft Front Seal and Wear Sleeve - Remove and Install
CG137-08 and CG137-12 Engines Crankshaft Rear Seal and Wear Sleeve - Remove and Install
CG137-08 and CG137-12 Engines Timing Gear Cover - Remove and Install
CG137-08 and CG137-12 Engines Timing Gears - Remove and Install
CG137-08 and CG137-12 Engines Valve Cover Base - Remove and Install - G3412B