301.4C Mini Hydraulic Excavator Caterpillar


Travel Motor

Usage:

301.4C LJ3


Illustration 1g02645058

Table 1
Specification for 381-3039 Travel Motor Gp 
Item  Qty  Part  Specification Description 
Maximum displacement per revolution is 85.05 cc (5.19 cubic inch)
Minimum displacement per revolution is 17.04 cc (1.04 cubic inch).
Maximum motor speed is 1008 rpm. 
Maximum pressure is 20000 kPa (2901 psi)
Peak pressure is 28000 kPa (4061 psi).

Caterpillar Information System:

301.4C Mini Hydraulic Excavator Hydraulic System Breather - Replace
301.4C Mini Hydraulic Excavator Fuel Injection Nozzles - Check/Adjust
301.4C Mini Hydraulic Excavator Hydraulic System Oil Filter (Pilot) - Check/Replace
301.4C Mini Hydraulic Excavator Swing Gear Grease - Check
345B Series II Excavator Machine System Specifications Bucket Cylinder
VHS-60/4 and VHS-70/4 Demolition and Scrap Shears Hydraulic Rotator Cycle Time - Check
VHS-60/4 and VHS-70/4 Demolition and Scrap Shears Hydraulic Cylinder Cycle Time - Check
320E and 323E Excavators Machine Systems Oil Filter (Hydraulic, Return)
301.4C Mini Hydraulic Excavator Quick Coupler Operation - Manual Pin Grabber Quick Coupler (If Equipped)
H110ES, H115ES, H120ES, H130ES, H140ES, H160ES and H180ES Hydraulic Hammers Hydraulic Hammer - Install
H110ES, H115ES, H120ES, H130ES, H140ES, H160ES and H180ES Hydraulic Hammers Hydraulic Hammer - Remove
Installation of the 275-1399 Front Lines Gp on Certain 320D Hydraulic Excavators{5057} Installation of the 275-1399 Front Lines Gp on Certain 320D Hydraulic Excavators{5057}
330D and 336D Excavators Machine System Specifications Return and Oil Filter Lines
330D and 336D Excavators Machine System Specifications Stick Cylinder
G3512 Gas Engine Flywheel
329E MHPU Mobile Hydraulic Power Unit Maintenance Interval Schedule
H110ES, H115ES, H120ES, H130ES, H140ES, H160ES and H180ES Hydraulic Hammers Pads - Remove and Install
320E RR Excavator Hydraulic System Swing Motor - Test - Measurement of Case Drain Oil
Instructions for Replacing the Support Plate on Certain SW60 Wheel Saws{6712} Instructions for Replacing the Support Plate on Certain SW60 Wheel Saws{6712}
320E RR Excavator Hydraulic System Relief Valve (Swing) - Test and Adjust
330D and 336D Excavators Machine System Specifications Hydraulic Generator
H110ES, H115ES, H120ES, H130ES, H140ES, H160ES and H180ES Hydraulic Hammers Wear Plates - Remove and Install
H110ES, H115ES, H120ES, H130ES, H140ES, H160ES and H180ES Hydraulic Hammers Control Valve - Remove
H110ES, H115ES, H120ES, H130ES, H140ES, H160ES and H180ES Hydraulic Hammers Control Valve - Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.