Swirl Plate (ARD Combustion) - Inspect/Clean
Show/hide table
所需工具 | |
工具 | 说明 |
A. | 油灰刮刀 |
B | 小号平头螺丝刀 |
C | 8S-2258 黄铜丝刷 |
- ARD 燃烧盖中包含一次性使用部件,关于拆卸 ARD 燃烧盖的正确步骤,请参阅拆解和组装, "燃烧盖总成(ARD)- 拆卸和安装 - 清洁排放模块"。
Show/hide table
图 1 g02615018 (1) 槽结垢
(2) ARD 燃油喷嘴注: 烟尘积聚量正常。 槽结垢定义为超过一半的内排槽完全堵塞。 内排槽部分堵塞属正常现象,不会影响再生性能。
- 检查 ARD 燃烧盖上的涡流片内排槽有无任何结垢或堵塞。
Show/hide table
图 2 g02615135 用工具 (A) 清洁涡流片 注: 切勿使用任何工具清洁 ARD 燃油喷嘴。 尝试清洁 ARD 燃油喷嘴将会导致喷嘴损坏。
- 如果发现槽结垢,则从使用工具 (A) 除去涡流片上的烟尘积聚物开始。
Show/hide table
图 3 g02615138 - 使用工具 (B) 除去可能嵌在槽中的所有现有的沉积物,从而确保所有槽都彻底清洁。
Show/hide table
图 4 g02615379 使用工具 (C) 除去积碳 - 使用工具 (C) 从涡流片上除去剩余的积碳。
注: 切勿用刷子清洗 ARD 燃油喷嘴。
注: 本步骤不需要任何清洁化学品。
- 重新安装 ARD 燃烧盖。 关于正确步骤,请参阅拆解和组装, "燃烧盖总成(ARD)- 拆卸和安装 - 清洁排放模块"。
Caterpillar Information System:
C13, C15, and C18 Tier 4 Final Engines Engine Oil Filter Base
C3.4B Engines For Caterpillar Built Machines Camshaft Bearings
C13, C15, and C18 Tier 4 Final Engines Piston and Rings
C13, C15, and C18 Tier 4 Final Engines Turbocharger
C13, C15, and C18 Tier 4 Final Engines Turbocharger
320E, 320F, 323E, 323F, 324E, 326F, 329E, 329F and 330F Excavators Tool Control System Medium Pressure Hydraulic System
2011/06/16 A New Flywheel Housing with Additional Holes for the Timing Pin Is Used on C175-16 Generator Set Engines {1157}
Using the 209-3153 Portable Hose Machine {0374, 0599, 0684, 0738, 5057} Using the 209-3153 Portable Hose Machine {0374, 0599, 0684, 0738, 5057}
2011/10/13 Replacement and Adjustment Procedures for the Fan Drive of Certain Commercial Engines {1359}
UPSB505 Uninterruptible Power Supply UPS Battery - 50Hz IGBT for CSIEN-CSION-CSPEN Circuit Board - Replace
UPSB505 Uninterruptible Power Supply UPS Battery - 50Hz Unit Final Check
UPSB505 Uninterruptible Power Supply UPS Battery - 50Hz Manual Transfer - Check
2011/06/24 An Additional One-Piece Steel Piston Is Available for Cylinder Packs That Are Utilized in Certain C15 On-Highway Truck Engines {1214, 1225}
992K Wheel Loader Fuel Tank Strainer - Clean
HVOF Identification and Polishing (Superfinishing){0674, 0679, 1000, 7000, 7562} HVOF Identification and Polishing (Superfinishing){0674, 0679, 1000, 7000, 7562}
C15 Generator Sets Model View Illustrations
CG137-08 and CG137-12 Engines Coolant Level - Check
XQ400 Power Module Gas Pressure Regulator Condensation - Drain
3500B Engines and 776D, 777D, 784C, 785C, 789C, 793C and 793D Off-Highway Truck/Tractors Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
C13, C15, and C18 Tier 4 Final Engines Engine Oil Filter Base
C13, C15, and C18 Tier 4 Final Engines Valve Mechanism Cover
C13, C15, and C18 Tier 4 Final Engines Valve Mechanism Cover
3500B Engines and 776D, 777D, 784C, 785C, 789C, 793C and 793D Off-Highway Truck/Tractors Engine Oil Pan
C4.4 Industrial Engine Crankshaft Gear (Balancer Drive) - Remove and Install