Fumes Disposal Filter - Drain
Show/hide table
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. |
- Shut down the engine.
Show/hide table
Illustration 1 g01891153 - Open oil condensation trap drain valve (1) and drain the fluid into a suitable container.
If the filter is installed and maintained properly, no more than
28 g (1 ounce) of fluid will be drained.If more than
28 g (1 ounce) is drained, make sure that the filter is installed properly. Ensure that the system is operating properly. - Close the condensation trap drain valve.
Resume normal operation.
Caterpillar Information System:
C15 and C18 Industrial Engines Flame Detection Temperature Sensor - Remove and Install - Clean Emissions Module
2009/04/20 How Is Service Information Accessed / Used {0374, 1000, 7000}
2009/04/27 An Improved Rod for the Recoil Spring is Now Used {4158}
795F AC and 795F AC XQ Off-Highway Trucks Air Filter Element (Inverter Cabinet) - Check
C9.3 Engines for Caterpillar Built Machines Customer Passwords
120 and 120 AWD Motor Grader Ether Starting Aid Cylinder - Replace
C13, C15, and C18 Generator Set Engines Belt Tightener
3500B and 3500C Marine Engines Alternator and Regulator
Adjustment of Overload Protection for Generators{4450, 4493} Adjustment of Overload Protection for Generators{4450, 4493}
C15 and C18 Industrial Engines Pressure Sensor (DPF) - Remove and Install
C7.1 Industrial Engine Electrical System
2009/04/27 Proper Long Term Storage of Caterpillar Products {0355, 1000, 7000}
793F and 797F Off-Highway Trucks Chassis Electronic Control System MID 087 - CID 0800 - FMI 09
C18 Marine Generator Set Configuration Parameters
C13 Tier 4 Final Engines Lubrication System
2009/05/04 A Repair Kit for the Magnet is Now Available for the AccuGrade CD700 Display {7490}
789D, 793F, and 797F Off-Highway Truck Monitoring System Connector Contact Description
C7.1 Industrial Engine and Generator Set No Diagnostic Codes Detected
C7.1 Industrial Engine and Generator Set Analog Throttle Position Sensor Circuit - Test
C13, C15, and C18 Tier 4 Final Engines Turbocharger
C11 and C13 Industrial Engines Turbocharger
C9.3 Engines for Caterpillar Built Machines Electrical Connectors - Inspect
3412C Generator Set Generator Bearing Temperature - Measure/Record
C27 and C32 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install - C32