C6.6 Industrial Engine Caterpillar


Fuel Injection Pump

Usage:

C6.6 667
Note: The timing of the fuel injection pump will need to be checked by trained personnel. In order to check the timing of the fuel injection pump, refer to Systems Operation, Testing and Adjusting, "Fuel Injection Pump Timing - Check".


NOTICE

Refer to Systems Operation, Testing and Adjusting, "Cleanliness of Fuel System Components" for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system.




Illustration 1g02293713
Typical example

(1) Tighten the studs to the following torque. ... 11 N·m (97 lb in)

(2) Tighten the mounting nut to the following torque. ... 22 N·m (16 lb ft)

(3) Tighten the fuel temperature sensor to the following torque. ... 22 N·m (16 lb ft)

(4) Tighten the setscrews to the following torque. ... 22 N·m (16 lb ft)

(5) Tighten the screws for the suction control valve to the following torque. ... 9 N·m (80 lb in)

(6) Tighten the screw to the following torque. ... 14 N·m (10 lb ft)

Caterpillar Information System:

C7.1 Industrial Engine and Generator Set Indicator Lamps
C6.6 Industrial Engine Fuel Injection Lines
G3520B Engine Maintenance Interval Schedule
C32 Marine Engine Battery Problem
C13, C15, and C18 Tier 4 Interim Engines Alternator Problem - Charging Problem and/or Noisy Operation
C15 and C18 Industrial Engines Fumes Disposal Filter - Remove and Install
C6.6 Industrial Engine Atmospheric Pressure Sensor
Procedure to Flush the Fuel System for the Aftertreatment Regeneration Device (ARD){3206} Procedure to Flush the Fuel System for the Aftertreatment Regeneration Device (ARD){3206}
C9.3 Tier 4 Interim Engines Coolant Temperature Is Low
793F and 797F Off-Highway Trucks Power Train Electronic Control System Electronic Control Module (ECM) - Configure
C15 and C18 Engines for Caterpillar Built Machines Front Cover - Remove and Install
C13 Engines for Caterpillar Built Machines Exhaust Manifold - Remove and Install
C6.6 Industrial Engine Fuel Filter Base - Single Secondary Fuel Filter Base
C13 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Springs - Remove and Install
C6.6 Industrial Engine Lifter Group
C9.3 Tier 4 Interim Engines Engine Cranks but Does Not Start
C15 and C18 Engines for Caterpillar Built Machines Cylinder Head - Remove and Install
793F CMD Off-Highway Truck (Command for Hauling) Power Train Electronic Control System Backup Alarm Does Not Function
C12 Marine Engines Heat Exchanger - Inspect/Clean
793F and 797F Off-Highway Trucks Braking System Brakes Drag
C13 Engine for Caterpillar Built Machines Inlet and Exhaust Valves - Remove and Install
C13 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
C13 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install - C15 Engine
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.