Removal Procedure
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 185-3630     | Strap Wrench As     | 1     |
Note: Cleanliness is an important factor. Before you begin the installation procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact the skin. Be sure that the engine and components are cool enough to touch with your bare hand prior to performing any service work. |
- Open access door (1) .
Illustration 1 | g01623193 |
- Remove cover assembly (2) .
Illustration 2 | g01623192 |
- Disconnect hose assemblies (4). Use Tooling (A) to remove oil filter (5). Remove oil filter base (3) .
Illustration 3 | g01623194 |
Installation Procedure
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
- Install oil filter base (3). Install oil filter (5). Connect hose assemblies (4).
Illustration 4 | g01623194 |
- Install cover assembly (2) .
Illustration 5 | g01623192 |
- Close access door (1) .
Illustration 6 | g01623193 |