C4.4 Generator Set Engines Caterpillar


ECM Will Not Accept Factory Passwords

Usage:

C4.4 CF7

Probable Causes

One of the following items may not be recorded correctly on the electronic service tool:

  • Passwords

  • Serial numbers

  • Total tattletale

  • Reason code

Recommended Actions

  1. Verify that the correct passwords were entered. Check every character in each password. Remove the electrical power from the engine for 30 seconds and then retry.

  2. Verify that the electronic service tool is displaying the "Enter Factory Passwords" dialog box.

  3. Use the electronic service tool to verify that the following information has been entered correctly:

    • Engine serial number

    • Serial number for the electronic control module

    • Serial number for the electronic service tool

    • Total tattletale

    • Reason code

For additional information, refer to Troubleshooting, "Factory Passwords".

Caterpillar Information System:

G3412C, G3508, G3512 and G3516 Engines Status Control Module Engine Shutdown Unexpected and All Fault Indicators Are Flashing
C4.4 Generator Set Engines Customer Specified Parameters Worksheet
C6.6 Marine Generator Set Cylinder Head
C4.4 Generator Set Engines Customer Specified Parameters Table
C18 Generator set and C18 Marine Engines Engine Support (Front) - Remove and Install
C4.4 Generator Set Engines Customer Specified Parameters
C4.4 Generator Set Engines Speed Demand Input Setup
C6.6 Marine Generator Set Cooling System Coolant (DEAC) - Change
C4.4 Generator Set Engines Engine Wiring Information
C6.6 Marine Generator Set Cylinder Head Valves
C4.4 Generator Set Engines Replacing the ECM
C4.4 and C6.6 Engines Electronic Service Tools
C4.4 Generator Set Engines Engine Cranks but Will Not Start
C4.4 and C6.6 Engines Engine Misfires, Runs Rough or Is Unstable
Diesel Fuel Cleanliness Analysis By Automatic Particle Counting {0680, 1250, 1280} Diesel Fuel Cleanliness Analysis By Automatic Particle Counting {0680, 1250, 1280}
2008/08/01 Improved Troubleshooting Guide for the 385-01 Fault Code {1130}
C9 Petroleum Engines Aftercooler Core - Clean/Test - Sea Water Cooled
G3412C, G3508, G3512 and G3516 Engines Status Control Module Fault Indicator Does Not Reset
G3412C, G3508, G3512 and G3516 Engines Status Control Module Engine Overcrank Occurrence
G3412C, G3508, G3512 and G3516 Engines Status Control Module Engine Overspeed Occurrence
C4.4 Generator Set Engines Excessive Fuel Consumption
C4.4 Generator Set Engines Excessive White Smoke
C4.4 Generator Set Engines Intake Air Temperature Is Too High
C6.6 Marine Generator Set Cooling System Coolant (ELC) - Change
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.