Front Housing and Covers
Show/hide table
 | |
| 图 1 | g01527834 |
(1) 缸体 (2) 前壳体 | |
注: 在将前壳体装至缸体之前涂抹 1U-8846 衬垫密封剂 至前壳体密封表面。 前壳体必须在 10 分钟内装配和紧固至缸体。
(3) 采用八条 M8 x 1.25 - 0.79 in 的螺栓。
(4) 采用四条 M8 x 1.25 - 1.97 in 的螺栓。
Show/hide table
 | |
| 图 2 | g01527833 |
(5) 前壳体盖 | |
(6) 采用 12 条 M8 x 1.25 - 1.18 in 的螺栓。
(7) 采用两条 M8 x 1.25 - 2.36 in 的螺栓。
(8) 将 154-9731 螺纹锁固胶 涂抹到螺柱的锯齿上后，再将螺柱安装到前壳体盖 (5) 内。
Caterpillar Information System:
C6.6 Marine Generator Set Turbocharger - Inspect
C15 On-highway Engine BrakeSaver Control Valve
C6.6 Marine Generator Set ECM Will Not Accept Factory Passwords
C6.6 Marine Generator Set EMCP3 Component Location
C6.6 Marine Generator Set Speed Demand Input Setup
345D, 349D and 349D2 Excavator Machine System Specifications Return Lines - Boom Float
345D, 349D and 349D2 Excavator Machine System Specifications Pilot Lines
C15 On-Highway Engine Exhaust Manifold
C15 On-highway Engine Exhaust Manifold
345D MHPU and 349D MHPU Mobile Hydraulic Power Units Machine System Cooling Lines - Hydraulic Oil
C6.6 Marine Generator Set Control Panel
345D, 349D and 349D2 Excavator Machine System Specifications Front Lines
345D, 349D and 349D2 Excavator Machine System Specifications Boom Cylinder Lines
Air Conditioning and Heating R134a for All Caterpillar Machines Refrigerant Orifice Tube Assembly
Transmission Clutch Plates and Disc Assemblies with F37 and F37X Friction Material {3030, 3155, 3190} Transmission Clutch Plates and Disc Assemblies with F37 and F37X Friction Material {3030, 3155, 3190}
C15 and C18 Petrolem Generator Set Engines Switch Circuits - Test
C15 On-highway Engine BrakeSaver
3054C Engines for Caterpillar Built Machines Fuel Injection Pump Timing - Adjust
C6.6 Marine Generator Set Engine Vibration
3500B Engines for Caterpillar Built Power Modules Turbocharger Oil Lines
3500 Engines Turbocharger Oil Lines
C6.6 Marine Generator Set Sensors and Electrical Components
C9 On-highway Engine Fuel Injection Lines
C15 and C18 Petrolem Generator Set Engines Direct Fuel Control Mode - Test