Engine Oil Pump - Assemble
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Ensure that all of the parts of the engine oil pump are thoroughly clean prior to assembly.
Note: Lubricate all internal parts of the engine oil pump with clean engine oil.
Show/hide table
Illustration 1 g01524205 - Install shaft (6) in oil pump body assembly (7). Install sleeve bearing (8) in idler gear (5). Install sleeve bearing (8) so the distance between the hub bolt face of idler gear (5) and sleeve bearing (8) is
0.75 ± 0.25 mm (0.030 ± 0.010 inch) . - Install idler gear (5) on shaft (6). Install washer (4) and bolt (3).
Show/hide table
Illustration 2 g01026664 - Check the condition of the gasket that is used in oil pickup tube (2). If the gasket is damaged, replace the gasket. Install the gasket and oil pickup tube (2).
- Check the condition of the O-ring seal that is used in outlet elbow (1). If the O-ring seal is damaged, replace the O-ring seal. Install the O-ring seal and outlet elbow (1).
End By:
- Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".
Caterpillar Information System:
Identification of Non-Metallic Discs that are Used in Power Shift Transmissions {3030, 3155} Identification of Non-Metallic Discs that are Used in Power Shift Transmissions {3030, 3155}
C175-16 and C175-20 Generator Set Engines Inlet Air Temperature Is High
C175-16 and C175-20 Generator Set Engines Exhaust Temperature Is Low
345D, 349D and 349D2 Excavators Hydraulic System Boom Drift Reduction Valve
2008/05/01 Improvements have been made to Remanufactured Fuel Injectors {1251, 1254, 1290, 1713}
2008/04/07 Improvements have been made to Remanufactured Fuel Injectors {1251, 1254, 1290, 1713}
2008/05/19 Improvements have been made to Remanufactured Fuel Injectors {1251, 1254, 1290, 1713}
C175-16 and C175-20 Generator Set Engines Exhaust Temperature Is High
C175-16 and C175-20 Generator Set Engines Coolant Temperature Is Low
C175-16 and C175-20 Generator Set Engines Coolant Temperature Is High
2008/03/01 A New Procedure for Installing the Internal Wiring Harness is Now Used {1120, 1408}
C175-16 and C175-20 Generator Set Engines Gear Group (Front)
C13, C15, and C18 Tier 4 Final Engines Speed/Timing Sensor
345D, 349D and 349D2 Excavator Machine System Specifications Swing Motor Lines
345D, 349D and 349D2 Excavator Machine System Specifications Hydraulic Oil Cooler Lines Group
C175-16 and C175-20 Generator Set Engines Cylinder Head Valves
C7 PETROLEUM Petroleum Engine Water Temperature Regulator - Remove and Install
C7 PETROLEUM Petroleum Engine Crankshaft Rear Seal - Install
2008/03/17 A New Bearing Block within the Governor is Now Used {1000}
C4.4 and C6.6 Engines for Caterpillar Built Machines Electrical Connectors - Inspect
C175-16 and C175-20 Generator Set Engines Engine Oil Pan
C175-16 and C175-20 Generator Set Engines Engine Oil Pan
C7 PETROLEUM Petroleum Engine Housing (Front) - Remove
C7 PETROLEUM Petroleum Engine Housing (Front) - Install