CX31 On-Highway Transmission Caterpillar


Magnetic Screen (Transmission) - Clean

Usage:

CX31 B3X

------ WARNING! ------

热油和热的部件可能会导致人员受伤。 不要让热的油和部件接触皮肤。



注意

在检验、保养、测试、调整及维修发动机时,请小心确保盛接流出的液体。 在打开或拆解任何储有液体的部件之前,要准备好合适的容器收集液体。

有关适合收集和盛接卡特彼勒产品上的液体的工具和供应品,请参阅专门出版物, NENG2500, "卡特彼勒代理商工具目录"。

按照本地法规和条例处置所有液体。





    图 1g01299022

    (1) 排放螺塞

  1. 从变速箱底部拆下排放螺塞 (1) 。 将机油排放到适当的容器中。

  1. 排放出变速箱壳体中的机油后, 清洁并安装排放螺塞。 将排放螺塞上紧固至 35 ± 10 N·m (26 ± 7 lb ft)。



    图 2g01274015

  1. 从检视板 (2) 上拆下 3 个螺栓。



    图 3g01237612

    (3) 吸入滤网

    (4) 磁性滤清器

  1. 拆下吸入滤网 (3) 。 拆下磁性滤清器 (4) 。

    注: 取下盖板后,可能会有更多机油从油底壳排出。 确保在其下放置一个适当的容器,以便盛放从变矩器壳体中可能放出的油。

  1. 检查吸入滤网 (3) 和磁性滤清器 (4) 是否有大颗粒碎屑。 过量的碎屑可能指示潜在的故障。 机油已变色或者机油有异味时,需要仔细分析 S·O·S 结果。 如果发现大的颗粒,请咨询您的 Caterpillar 代理商,进行进一步的分析和详细的指导。


    注意

    不要将磁铁跌落或敲击任何硬物。 磁铁极易脆裂。 更换已破损的磁铁或滤网。


  1. 用干净且不易燃的溶剂来清洗吸入滤网和磁性滤清器。 使用布或硬毛刷清洁磁铁。

  1. 安装磁性滤清器、滤网和检视板。 将检视板紧固至 28 ± 7 N·m (21 ± 5 lb ft)。



    图 4g01299025

    (5) 加注管

  1. 使用建议的机油粘度和加注量,给变速箱加注机油直至加注到加注管 (5) 油尺上的满位标记。 请参阅操作和保养手册, "再加注容量",了解正确的机油加注容量。

  1. 车辆须停放在水平地面且变速箱处于空档。 起动发动机并在低怠速下运转。 检查机油滤清器和吸入网是否泄露。

  1. 当油温热和变速箱在空档位置时,观察油位。 确保停车制动器已接合。

  1. 关闭发动机。 如有需要,加注机油。

Caterpillar Information System:

CX31 On-Highway Transmission Capacities (Refill)
XQP150 Rental Generator Set Water Pump - Inspect
CX31 On-Highway Transmission Retarder Operation
Inspecting the Fuel System for the Aftertreatment Regeneration Device (ARD){107P, 1088, 1722} Inspecting the Fuel System for the Aftertreatment Regeneration Device (ARD){107P, 1088, 1722}
CX31 On-Highway Transmission Transmission Operation
G3500 A3 Engines Low Power/Poor or No Response to Throttle
C6.6 Engines for Caterpillar Built Machines Fuel Priming Pump - Remove and Install - Mechanical Priming Pump
3408C and 3412C Marine Engines Engine Oil Lines
C13 and C15 On-highway Engines Output Selection Parameters
C13 and C15 On-highway Engines Vehicle Speed Parameters
C13 and C15 On-highway Engines Vehicle Activity Report Parameters
C13 and C15 On-highway Engines Trip Parameters
CX31 On-Highway Transmission Oil Filter (Transmission) - Replace
CX31 On-Highway Transmission Reference Material
C32 Power Module Fuel System Primary Filter/Water Separator - Drain
Troubleshooting Fuel Injector Failures on Some C13 and C15 On-highway Engines{1290, 1408} Troubleshooting Fuel Injector Failures on Some C13 and C15 On-highway Engines{1290, 1408}
2007/07/16 High Copper Reported in Routine Engine Oil Samples {1308, 1318, 1348}
C13, C15, and C18 Tier 4 Final Engines Exhaust Manifold
12M Motor Grader Before Operation
C11 and C13 Engines and 14M and 16M Motor Graders Sensor Signal (Analog, Passive) - Test
C9 Petroleum Engines Engine Oil and Filter - Change
A Recommendation for Initial Parts Stock Quantities Will Now Be Included in Service Letters{1000, 7000, 7751, 7752} A Recommendation for Initial Parts Stock Quantities Will Now Be Included in Service Letters{1000, 7000, 7751, 7752}
Reusability of Drive Train Gears {3002, 3159, 3256, 4055} Reusability of Drive Train Gears {3002, 3159, 3256, 4055}
C11 and C13 Petroleum Engines Warranty Information
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.