Oil Filter and Base (Transmission Charging) - Assemble
组装步骤
注: 检查 O 形密封圈。 更新所有磨损或损坏的 O 形密封圈。
注: 安装 O 形密封圈时，用要密封的油液润滑 O 形密封圈。
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 安装 O 形密封圈 (13) 。 安装 O 形密封圈 (12) 。
Show/hide table
 | |
| 图 1 | g01262174 |
- 安装阀芯组件 (11) 。
Show/hide table
 | |
| 图 2 | g01262173 |
- 安装护圈 (10) 。
Show/hide table
 | |
| 图 3 | g01262170 |
- 安装阀芯组件 (9) 。
Show/hide table
 | |
| 图 4 | g01262167 |
- 将 O 形密封圈 (8) 安装到护圈 (7) 上。
Show/hide table
 | |
| 图 5 | g01262165 |
- 安装护圈 (7) 。 安装螺母 (6) 。 拧紧螺母 (6) 至扭矩为 30 ± 5 N·m (22 ± 4 lb ft)。
Show/hide table
 | |
| 图 6 | g01262164 |
- 安装盖 (5) 。
Show/hide table
 | |
| 图 7 | g01262160 |
- 安装弹簧 (4) 。
Show/hide table
 | |
| 图 8 | g01262154 |
Show/hide table
 | |
| 图 9 | g01262156 |
Show/hide table
 |
弹簧压缩零件如果安装不当，会伤害人体。 为避免伤害，遵照出版的装配程序，并穿上保护装备。 |
- 安装滑阀 (3) 。
- 安装开关 (2) 。 拧紧开关 (2) 至扭矩 80 ± 10 N·m (59 ± 7 lb ft)。
- 安装支架 (1) 。
Show/hide table
 | |
| 图 10 | g01262150 |
End By: 安装变速箱机油滤清器和底座。 请参阅 拆解和组装, "机油滤清器和底座（变速箱充油）- 安装"。
Caterpillar Information System:
793D Off-Highway Truck Power Train Oil Filter and Base (Transmission Charging) - Disassemble
AccuGrade® GPS Using The CD550A Display (GPS/ATS/Sonic/Cross Slope) Module - Replace
2006/07/24 Improved Drain for Electronics Bay {1408, 5201, 7276}
AccuGrade® GPS Using The CD550A Display (GPS/ATS/Sonic/Cross Slope) GPS Accuracy Mode
773F and 775F Off-Highway Truck Magnetic Screen (Transmission) - Clean
Filtration Procedure for Off-Highway Truck and Rotary Drill Hydraulic Oil {0680, 0768, 5050, 5056} Filtration Procedure for Off-Highway Truck and Rotary Drill Hydraulic Oil {0680, 0768, 5050, 5056}
12M Motor Grader Battery Disconnect Switch
777F Off-Highway Truck Hydraulic System Brake Hydraulic System
770 and 772 Off-Highway Truck Steering System Visual Inspection
C7 PETROLEUM Petroleum Engine Air Inlet Heater - Remove and Install
279C, 279C2, 289C, 289C2 and 299C Compact Track Loaders, 287C, 277C, 277C2, 287C2 and 297C Multi Terrain Loaders and 246C, 256C, 262C, 262C2 and 272C Skid Steer Loaders Monitoring System Service Mode
C9.3 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
777G Off-Highway Truck Automatic Lubrication System (Type A1) Lubrication Injectors - Adjust
AccuGrade® GPS Using The CD550A Display (GPS/ATS/Sonic/Cross Slope) Module - Flash Program
777E and 777F Off-Highway Truck Power Train System Information (Power Train)
777E and 777F Off-Highway Truck Automatic Lubrication System Lubrication Injector Banks - Adjust
The Instructions for the Field Installation of the New 284-8541 Backhoe Lines Gp (Kit) (Field Conversion){5057} The Instructions for the Field Installation of the New 284-8541 Backhoe Lines Gp (Kit) (Field Conversion){5057}
C7 PETROLEUM Petroleum Engine Water Temperature Regulator - Remove and Install
583T Pipelayer Engine Supplement Air Cleaner - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines CID 0533 FMI 09 Brake Control abnormal update rate
C27 and C32 Engines for Caterpillar Built Machines CID 0533 FMI 14 Brake Control special instruction
279C, 279C2, 289C, 289C2 and 299C Compact Track Loaders, 287C, 277C, 277C2, 287C2 and 297C Multi Terrain Loaders and 246C, 256C, 262C, 262C2 and 272C Skid Steer Loaders Monitoring System System Schematic
R1700G Load Haul Dump Machine Systems Control Valve (Wheel Steering) - Remove
R1700G Load Haul Dump Power Train MID 081 - CID 0070 - FMI 03