Fan - Remove and Install
Start By:
- Remove the V-Belts. Refer to this Disassembly and Assembly Manual, "V-Belts - Remove and Install".
- Remove the nuts (4).
- Remove the fan (1).
- If equipped, remove the studs (3).
- If equipped, remove the extension (2) for the fan (1).
- Remove the fan pulley.
Show/hide table
Illustration 1 | g01229663 |
Typical example |
- Inspect the condition of the fan pulley. Replace the fan pulley, if necessary.
- Install the fan pulley.
- If the engine is equipped with an extension for the fan, install the extension (2).
- If equipped, install the studs (3).
- Inspect the condition of the fan (1) and replace the fan, if necessary.
- Install the fan (1).
Show/hide table
Illustration 2 g01229663 Typical example - Install the nuts (4). Tighten the nuts (1) to a torque of
12 N·m (9 lb ft) .
End By:
- Install the V-Belts. Refer to this Disassembly and Assembly Manual, "V-Belts - Remove and Install".
Caterpillar Information System:
C3.3 Industrial Engine Electric Starting Motor - Remove and Install
TH31 Well Servicing Transmissions Pump Drive - Assemble
TH31 Well Servicing Transmissions Transmission and Scavenge Oil Pump - Assemble
TH31 Well Servicing Transmissions Transmission and Scavenge Oil Pump - Install
TH31 Well Servicing Transmissions Transmission and Scavenge Oil Pump - Remove
TH31 Well Servicing Transmissions Transmission Planetary - Assemble
C6.6 Engines for Caterpillar Built Machines Electronic Control System Components
2006/02/20 New Supplier for Glow Plugs {1412}
TH31 Well Servicing Transmissions Transmission and Scavenge Oil Pump - Disassemble
TH31 Well Servicing Transmissions Transmission and Torque Converter - Connect
3512B Oil Well Servicing Engine (ADEM III) Electrical Power Supply
C175 Generator Set Engines Idler Gears (Front) - Remove and Install
C3.3 Industrial Engine Glow Plugs - Remove and Install - If Equipped
TH35 Well Servicing Transmissions Transmission Planetary - Assemble
3126B and 3126E Truck Engines Vibration Damper
The Valve Body May Crack on Certain Remanufactured Fuel Injectors{1290} The Valve Body May Crack on Certain Remanufactured Fuel Injectors{1290}
Installation of the Machine Security System (MSS) Universal Attachment Kit {7631, 7631} Installation of the Machine Security System (MSS) Universal Attachment Kit {7631, 7631}
C6.6 Engines for Caterpillar Built Machines Basic Engine
Reman Alternator Failures {1405} Reman Alternator Failures {1405}
C175-16 and C175-20 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
2006/01/02 A Different Grommet is Used to Secure the Engine Wiring Harness {1408}
TH31 Well Servicing Transmissions Transmission and Torque Converter - Separate
C3.3 Industrial Engine Crankshaft Gear - Remove and Install
C3.3 Industrial Engine Crankshaft - Install