Electric Starting Motor - Remove and Install
- Ensure that the battery is disconnected or isolated.
- Place an identification mark on all of the harness assemblies that are connected to the starting motor (4).
Show/hide table
Illustration 1 g00999973 Typical Example - Disconnect the ground harness assembly (1) from the starting motor (4).
- Disconnect the harness assembly (2) and disconnect the harness assembly (3) from the starting motor (4).
Show/hide table
Illustration 2 g00999956 Typical Example - Remove the nuts (5) from the studs.
- Remove the electric starting motor (4) from the flywheel housing.
- Install the electric starting motor (4) onto the flywheel housing.
- Install the nuts (5) onto the studs. Tighten the nuts (5) to a torque of
44 N·m (32 lb ft) .Show/hide tableIllustration 4 g00999973 Typical Example - Connect the harness assembly (3), and the harness assembly (2) to the electric starting motor (4). Refer to the Specifications Manual, "Starter Motor" for the appropriate torques for the terminal nuts.
- Connect the harness assembly (1) to the electric starting motor (4). Refer to the Specifications Manual, "Starter Motor" for the appropriate torques for the terminal nuts.
- Turn the isolator for the battery to the ON position or reconnect the battery.
Show/hide table
Illustration 3 | g00999956 |
Typical Example |
Caterpillar Information System:
TH31 Well Servicing Transmissions Pump Drive - Assemble
TH31 Well Servicing Transmissions Transmission and Scavenge Oil Pump - Assemble
TH31 Well Servicing Transmissions Transmission and Scavenge Oil Pump - Install
TH31 Well Servicing Transmissions Transmission and Scavenge Oil Pump - Remove
TH31 Well Servicing Transmissions Transmission Planetary - Assemble
C6.6 Engines for Caterpillar Built Machines Electronic Control System Components
2006/02/20 New Supplier for Glow Plugs {1412}
TH31 Well Servicing Transmissions Transmission and Scavenge Oil Pump - Disassemble
TH31 Well Servicing Transmissions Transmission and Torque Converter - Connect
3512B Oil Well Servicing Engine (ADEM III) Electrical Power Supply
C175 Generator Set Engines Idler Gears (Front) - Remove and Install
2006/01/02 New Bevel Gear And Pinions And Associated Components Provide Increased Service Life {3254, 3256}
C3.3 Industrial Engine Fan - Remove and Install
C3.3 Industrial Engine Glow Plugs - Remove and Install - If Equipped
TH35 Well Servicing Transmissions Transmission Planetary - Assemble
3126B and 3126E Truck Engines Vibration Damper
The Valve Body May Crack on Certain Remanufactured Fuel Injectors{1290} The Valve Body May Crack on Certain Remanufactured Fuel Injectors{1290}
Installation of the Machine Security System (MSS) Universal Attachment Kit {7631, 7631} Installation of the Machine Security System (MSS) Universal Attachment Kit {7631, 7631}
C6.6 Engines for Caterpillar Built Machines Basic Engine
Reman Alternator Failures {1405} Reman Alternator Failures {1405}
C175-16 and C175-20 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
2006/01/02 A Different Grommet is Used to Secure the Engine Wiring Harness {1408}
TH31 Well Servicing Transmissions Transmission and Torque Converter - Separate
C3.3 Industrial Engine Crankshaft Gear - Remove and Install