Crankshaft Rear Seal - Install
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 4C-9612     | Silicone Sealant     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean the back of the cylinder block and the mating surface of the backplate.
- Install crankshaft rear seal (1) on the cylinder block.
Show/hide table
Illustration 1 | g00847841 |
- Apply a bead of Tooling (A) around the bolt holes and the face of the cylinder block.
- Position backplate (2) on the rear of the cylinder block.
- Install bolts (3) that fasten backplate (2) on the cylinder block. Tighten the bolts to a torque of 25 N·m (18 lb ft).
End By: Install the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install".
Caterpillar Information System:
2004/07/01 Procedure for Cylinder Head Bolt Tightening {1100}
3126E Truck Engines Refill Capacities and Recommendations
C-15 Petroleum Engine Exhaust Manifold
C1.5 and C2.2 Marine Generator Set Engines Water Temperature Regulator - Remove and Install
3126E and 3126B Commercial and Truck Engines Engine Oil Level Gauge - Calibrate
C32 Marine Engine Gear Group (Front) - Time
G3500 Engines Desired Engine Speed Signal
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Install
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Remove
2003/11/01 Special Instruction for Testing Oil Coolers {1378}
C32 Marine Engine Air Inlet and Exhaust System
C1.5 and C2.2 Marine Generator Set Engines Exhaust Manifold - Remove and Install
2003/12/01 New Seal for the Ignition Transformer Tube {1561}
C-15 Petroleum Engine Flywheel Housing
2003/12/01 Special Instruction for Testing Oil Coolers {1378}
General Welding Procedures {0679, 7000} General Welding Procedures {0679, 7000}
SPP101 Skid Mounted Pumper Refill Capacities
Oxidation Catalyst Converter for Stationary Engines and Non-Road Mobile Engines {1091} Oxidation Catalyst Converter for Stationary Engines and Non-Road Mobile Engines {1091}
C9 Marine Auxiliary and Marine Generator Set Engines Sensors and Electrical Connectors
C12 Marine Engines Gauges and Indicators
C9 Marine Auxiliary and Marine Generator Set Engines System Configuration Parameters
2003/12/01 A New Oil Filler Tube and New Oil Filler Cap Are Now Available {1316}
2003/12/01 A New Oil Filler Tube and New Oil Filler Cap are Now Available {1316}
C32 Marine Engine Coolant Temperature Sensor