Procedure for Cylinder Head Bolt Tightening {1100}
- Caterpillar Products: All
- 3500B Engines
Reference: Refer to Guideline for Reusable Parts and Salvage Operations, SEBF8301, "Inspection and Reuse of Critical Fasteners Used in All Engines" for reuse information for the cylinder head bolts.
Use the following procedure to tighten the cylinder head bolts.
- Coat the threads of the cylinder head bolts with clean engine oil.
- Tighten bolts 1 through 8 in the numbered sequence that is pictured in Illustration 1.
Torque ... 30 ± 5 N·m (22 ± 4 lb ft)
- Tighten bolts 1 through 8 in the numbered sequence.
Torque ... 200 ± 15 N·m (148 ± 11 lb ft)
Show/hide table
Illustration 1 | g01037430 |
- Tighten bolts 1 through 8 again in the numbered sequence.
Torque ... 200 ± 15 N·m (148 ± 11 lb ft)
- Tighten bolts 1 through 8 again to the following rotation.
Rotation for bolts ... 180 ± 5 degrees
- Tighten bolt 9 and bolt 10.
Torque ... 55 ± 10 N·m (40 ± 7 lb ft)
Caterpillar Information System:
3126E Truck Engines Refill Capacities and Recommendations
C-15 Petroleum Engine Exhaust Manifold
C1.5 and C2.2 Marine Generator Set Engines Water Temperature Regulator - Remove and Install
3126E and 3126B Commercial and Truck Engines Engine Oil Level Gauge - Calibrate
C32 Marine Engine Gear Group (Front) - Time
G3500 Engines Desired Engine Speed Signal
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Install
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Remove
2003/11/01 Special Instruction for Testing Oil Coolers {1378}
C32 Marine Engine Air Inlet and Exhaust System
C1.5 and C2.2 Marine Generator Set Engines Exhaust Manifold - Remove and Install
C32 Marine Engine General Information
C1.5 and C2.2 Marine Generator Set Engines Crankshaft Rear Seal - Install
2003/12/01 New Seal for the Ignition Transformer Tube {1561}
C-15 Petroleum Engine Flywheel Housing
2003/12/01 Special Instruction for Testing Oil Coolers {1378}
General Welding Procedures {0679, 7000} General Welding Procedures {0679, 7000}
SPP101 Skid Mounted Pumper Refill Capacities
Oxidation Catalyst Converter for Stationary Engines and Non-Road Mobile Engines {1091} Oxidation Catalyst Converter for Stationary Engines and Non-Road Mobile Engines {1091}
C9 Marine Auxiliary and Marine Generator Set Engines Sensors and Electrical Connectors
C12 Marine Engines Gauges and Indicators
C9 Marine Auxiliary and Marine Generator Set Engines System Configuration Parameters
2003/12/01 A New Oil Filler Tube and New Oil Filler Cap Are Now Available {1316}
2003/12/01 A New Oil Filler Tube and New Oil Filler Cap are Now Available {1316}