Exhaust Manifold
Show/hide table
Illustration 1 | g01037298 |
Water cooled exhaust manifold (Typical example) |
Show/hide table
Illustration 2 | g00592627 |
Tightening sequence |
(1) Torque for exhaust manifold nuts ... 38 ± 5 N·m (28 ± 4 lb ft)
Note: Refer to Illustration 2 for the tightening sequence.
(2) Lubricate the bore lightly with glycerin.
Caterpillar Information System:
C1.5 and C2.2 Marine Generator Set Engines Water Temperature Regulator - Remove and Install
3126E and 3126B Commercial and Truck Engines Engine Oil Level Gauge - Calibrate
C32 Marine Engine Gear Group (Front) - Time
G3500 Engines Desired Engine Speed Signal
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Install
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Remove
2003/11/01 Special Instruction for Testing Oil Coolers {1378}
C32 Marine Engine Air Inlet and Exhaust System
C1.5 and C2.2 Marine Generator Set Engines Exhaust Manifold - Remove and Install
C32 Marine Engine General Information
C8.7 Marine Engine Gauges and Indicators
C32 Marine Engine Electric Starting Motor
3126E Truck Engines Refill Capacities and Recommendations
2004/07/01 Procedure for Cylinder Head Bolt Tightening {1100}
C1.5 and C2.2 Marine Generator Set Engines Crankshaft Rear Seal - Install
2003/12/01 New Seal for the Ignition Transformer Tube {1561}
C-15 Petroleum Engine Flywheel Housing
2003/12/01 Special Instruction for Testing Oil Coolers {1378}
General Welding Procedures {0679, 7000} General Welding Procedures {0679, 7000}
SPP101 Skid Mounted Pumper Refill Capacities
Oxidation Catalyst Converter for Stationary Engines and Non-Road Mobile Engines {1091} Oxidation Catalyst Converter for Stationary Engines and Non-Road Mobile Engines {1091}
C9 Marine Auxiliary and Marine Generator Set Engines Sensors and Electrical Connectors
C12 Marine Engines Gauges and Indicators
C9 Marine Auxiliary and Marine Generator Set Engines System Configuration Parameters