Gear Group (Front) - Time
Show/hide table
| |
| Illustration 1 | g00847237 |
|
Front gear group (1) Pump drive gear (2) Camshaft gear (3) Water pump drive gear (4) Accessory drive gear (5) Idler gear (6) Plate (7) Crankshaft gear (8) Engine oil pump drive gear | |
Align the "H" marks on pump drive gear (1) and camshaft gear (2).
Align the "V" marks on camshaft gear (2) and idler gear (5).
Align the "V" marks on balancer gear (5) and crankshaft gear (7).
Note: If one or more of the gears need to be removed for repair, refer to Disassembly and Assembly, "Gear Group (Front) - Remove" in order to properly remove the gears. Refer to Disassembly and Assembly, "Gear Group (Front) - Install" in order to properly install the gears.
Inspect the gears for wear or for damage. If the gears are worn or damaged, use new parts for replacement.
Caterpillar Information System:
G3500 Engines Desired Engine Speed Signal
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Install
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Remove
2003/11/01 Special Instruction for Testing Oil Coolers {1378}
C32 Marine Engine Air Inlet and Exhaust System
C1.5 and C2.2 Marine Generator Set Engines Exhaust Manifold - Remove and Install
C32 Marine Engine General Information
C8.7 Marine Engine Gauges and Indicators
C32 Marine Engine Electric Starting Motor
C32 Marine Engine Sensors and Electrical Components
C9 Marine Auxiliary and Generator Set Engines Model View Illustrations
EMCP3 Electronic Control Module (Engine) - Electronic Unit Injection (EUI) Engines Only
3126E and 3126B Commercial and Truck Engines Engine Oil Level Gauge - Calibrate
C1.5 and C2.2 Marine Generator Set Engines Water Temperature Regulator - Remove and Install
C-15 Petroleum Engine Exhaust Manifold
3126E Truck Engines Refill Capacities and Recommendations
2004/07/01 Procedure for Cylinder Head Bolt Tightening {1100}
C1.5 and C2.2 Marine Generator Set Engines Crankshaft Rear Seal - Install
2003/12/01 New Seal for the Ignition Transformer Tube {1561}
C-15 Petroleum Engine Flywheel Housing
2003/12/01 Special Instruction for Testing Oil Coolers {1378}
General Welding Procedures {0679, 7000} General Welding Procedures {0679, 7000}
SPP101 Skid Mounted Pumper Refill Capacities
Oxidation Catalyst Converter for Stationary Engines and Non-Road Mobile Engines {1091} Oxidation Catalyst Converter for Stationary Engines and Non-Road Mobile Engines {1091}