Belt Tension Chart
Note: Do not use the belt tension chart for belts with tensioners that are spring loaded.
Show/hide table
| Belt Tension Chart | ||
| Belt Type | Deflection | Applied Force for Specified Deflection |
| Type B | 10 to 12 mm (0.4 to 0.6 inch) |
98 N (22 lb) |
Caterpillar Information System:
2003/08/01 New Hose Improves the Drainage of Oil from the Turbocharger During a Continuous Prelube Cycle {1052}
G3500B Engines Compressor Bypass - Check
Circuit Breaker Harness Assembly {1420} Circuit Breaker Harness Assembly {1420}
3406E, C-10, C-12, C-15, C-16 Truck Engines Refill Capacities and Recommendations
C15 On-highway Engine Inlet and Exhaust Valve Springs - Remove and Install
C15 and C18 Generator Set Engines Cylinder Liner - Remove
C15 and C18 Generator Set Engines Cylinder Liner - Install
3126E and 3126B Commercial and Truck Engines Engine Oil and Filter - Change
2003/12/01 SOLAS Requirements for Fuel Lines {1274}
C11 and C13 Engines Diverter Valve (Coolant) - Remove
C11 and C13 Engines Engine Oil Cooler - Remove
C11 and C13 Engines Crankshaft - Install
3044C Industrial Engine and Engines for Caterpillar Built Machines Alternator and Regulator
3044C Industrial Engine and Engines for Caterpillar Built Machines Electric Starting Motor
C11 and C13 Engines Air Compressor Drive Gear - Remove and Install
C27 and C32 Generator Set Engines Camshaft Bearings - Remove
C27 and C32 Generator Set Engines Camshaft Bearings - Install
C11 and C13 Engines Diverter Valve (Coolant) - Install
2003/08/01 Diagnosis of Failure of Exhaust Valve {1105}
G3406 Engines Camshaft
C11 and C13 Engines Precooler - Remove
3408E and 3412E Engines for Caterpillar Built Machines Cylinder Block
C11 and C13 Engines Precooler - Install
G3500B Engines Engine Crankcase Breather - Clean