Track Adjustment - Adjust
- Remove the cover plate for the track adjustment valve.
Show/hide table
Illustration 2 g00523707 - Wipe the fitting before you add grease.
- Add grease through the valve fitting until the correct tension is reached.
- Operate the track back and forth in order to equalize the pressure.
- Check the amount of sag. Adjust the track, as needed. Refer to Operation and Maintenance, "Track Adjustment - Inspect".
- Replace the cover plate for the track adjustment valve.
- Repeat the same procedure for the other track.
Show/hide table
Illustration 1 | g00523702 |
Show/hide table
Personal injury or death can result from grease under pressure. Grease coming out of the relief valve under pressure can penetrate the body causing injury or death. Do not watch the relief valve to see if grease is escaping. Watch the track or track adjustment cylinder to see if the track is being loosened. Loosen the relief valve one turn only. If track does not loosen, close the relief valve and contact your Caterpillar dealer. |
- Loosen the filler valve carefully until the track begins to loosen. One turn should be the maximum.
- Tighten the filler valve to
34 N·m (25 lb ft) when the desired track tension is reached. - Operate the track back and forth in order to equalize pressure.
- Check the amount of sag in the track. Adjust the track, as needed. Refer to Operation and Maintenance, "Track Adjustment - Inspect".
- Repeat the same procedure for the other track.
Show/hide table
Illustration 3 | g00523707 |
If the correct adjustment cannot be achieved consult your Caterpillar dealer.
Caterpillar Information System:
304 CR Mini Hydraulic Excavator Hydraulic System Boom Hydraulic System
304 CR Mini Hydraulic Excavator Access Door and Cover Locations
5230 Excavator Hydraulic System Swing Parking Brake
Air Conditioning and Heating R134a for All Caterpillar Machines Refrigerant Compressor
5230 Excavator Hydraulic System Swing Motor
307C Excavator Machine Systems Main Hydraulic Pump - Install
330C Excavator Machine Systems Stick - Remove
330C Excavator Machine System Specifications Recoil Spring
302.5 Mini Hydraulic Excavator Cab Door - If Equipped
304 CR Mini Hydraulic Excavator Specifications
330C Excavator Specifications - Retrofit Boom
385B and 5090B Excavators Excavator Systems Bucket Linkage - Install
330C Excavator Machine Systems Boom Cylinder - Remove
302.5 Mini Hydraulic Excavator Circuit Breakers - Reset
325C Excavator Cab Tilt Control - If Equipped
325C Excavator Joystick Controls
330C Excavator Work Tool Control
2007/08/20 C-12/3176C/3196 Front Housing Bolts {1151}
304 CR Mini Hydraulic Excavator Hydraulic System Swing Boom Hydraulic System
322C and 325C Forest Machines Hydraulic System Travel Hydraulic System
307C Excavator Engine Supplement Air Inlet Manifold - Remove
318C Excavator Tool Control System Controller
3306C Engines for Caterpillar Built Machines Alternator and Regulator
303.5 Mini Hydraulic Excavator Lubricant Viscosities