Mounting Bracket
Show/hide table
Illustration 1 | g00729570 |
Typical Example |
(1) Torque on the 14 bolts ... 1000 ± 125 N·m (738 ± 92 lb ft)
Caterpillar Information System:
MP-15, MP-20, MP-30 and MP-40 Multi Processors Hydraulic Rotator Cycle Time - Check
320C Excavator Fine Swing Control - If Equipped
320C Excavator Automatic Engine Speed Control (AEC)
320C Excavator Engine Speed Control
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket - Remove and Install
MP-15, MP-20, MP-30 and MP-40 Multi Processors Control Valve Pressure (Hydraulic Rotator) - Test
3126B Engines Electrical System
320C Excavator Window Wiper and Washer Control
H140C S and H160C S Hydraulic Hammers Mounting Bracket Bolts - Tighten
320C Excavator Cab Door
325C and 325C L Excavator Alternate Exit
MP-15, MP-20, MP-30 and MP-40 Multi Processors Speed Control Valve (Hydraulic Cylinder) - Test and Adjust
3176C and 3196 Engines for Caterpillar Built Machines Intermittent Low Power or Power Cutout
3126B Engines Electronic Control System Components
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket
MP-15, MP-20, MP-30 and MP-40 Multi Processors Shear Jaw
JF Series Starting Motor Pinion Continues to Engage after Engine Starts
MP-15, MP-20, MP-30 and MP-40 Multi Processors Multi-Processor Housing
MP-15, MP-20, MP-30 and MP-40 Multi Processors Multi-Processor Housing
3176C and 3196 Engines for Caterpillar Built Machines Poor Acceleration or Response
MP-15, MP-20, MP-30 and MP-40 Multi Processors Multi-Processor Housing
3126B Engines General Information
5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) System Schematic