Mounting Bracket - Remove and Install
Removal Procedure
Start By:
- Remove the work tool from the host machine. Refer to Operations and Maintenance Manual, SEBU7391, "Work Tool Installation and Removal".
Show/hide table
Illustration 1 | g00729140 |
Typical Example |
When possible, position the work tool upright. The work tool should only be positioned in this manner on a solid, level surface. Refer to Illustration 1 for proper positioning of the work tool. If a solid level surface is not available, lay the work tool on a side.
- Attach an appropriate nylon lifting sling and a hoist to mounting bracket (1). The weight of the brackets are listed in Table 1.
- Remove the bolts and the washers from the mounting bracket. Lift the mounting bracket from the work tool.
Show/hide table
Part Number (Mounting Bracket)     | Weight of the Mounting Bracket     | |
169-4967     | 194 kg (428 lb)     |
|
169-5311     | 167 kg (368 lb)     |
|
169-5312     | 148 kg (326 lb)     |
Installation Procedure
- Attach an appropriate nylon lifting sling and a hoist to mounting bracket (1). The weight of the brackets are listed in Table 1. Lift the mounting bracket into position on the work tool.
Show/hide table
Illustration 2 | g00729140 |
Typical Example |
- Install the bolts and the washers to the mounting bracket. Tighten the bolts to a torque of 1000 ± 125 N·m (738 ± 92 lb ft).
Caterpillar Information System:
307C Excavator Hydraulic System Main Pump (Flow) - Test
JF Series Starting Motor Starting Motor Solenoid - Test
2000/10/30 Part Numbers for Electric Motors That Are Used in HVAC Have Changed {5927}
M318 Excavator Hydraulic System Relief Valve (Line) - Test and Adjust - Travel Motor
JF Series Starting Motor Starting Motor Continues to Operate after Start Switch Has Been Released
JF Series Starting Motor Pinion Does Not Engage Ring Gear While Armature Turns
307C Excavator Hydraulic System Relief Valve (Swing) - Test and Adjust
2000/08/07 The Assembly Procedure for the Main Hydraulic Pump Is Changed {5070}
2000/08/28 New Hydraulic Oil Coolers with Copper-Nickel Alloy Tubes Resist Corrosion {1374}
330C Excavator Light Switches
307C Excavator Travel Alarm - If Equipped
320C Excavator Clock Adjustment
325D and 329D Excavators Radio - If Equipped
3176C and 3196 Engines for Caterpillar Built Machines Engine Cranks but Will Not Start
320C Excavator Storage Box
320C Excavator Seat Heater - If Equipped
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket - Remove and Install
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket - Remove and Install
330C Excavator Window (Front)
MP-15, MP-20, MP-30 and MP-40 Multi Processors Speed Control Valve (Hydraulic Cylinder) - Test and Adjust
325C and 325C L Excavator Alternate Exit
320C Excavator Cab Door
H140C S and H160C S Hydraulic Hammers Mounting Bracket Bolts - Tighten
320C Excavator Window Wiper and Washer Control