Improved Transmission Direction Rocker Switch is Now Available {1611}
- Wheel Skidder:
- 515 (S/N: 4LR1-UP)
- Wheel Tractor:
- 824G (S/N: 4SN1-UP)
- Wheel Loader:
- 980G (S/N: 2KR1-UP; 2SR1-UP; 9CM1-UP)
- Earthmoving Compactor:
- 825G (S/N: 6RN1-UP)
- 525 (S/N: 1DN1-UP)
- 545 (S/N: 2FZ1-UP)
- 844 (S/N: 2KZ1-UP)
- 854G (S/N: 1JW1-UP)
- 988F (S/N: 8YG1-UP)
- 988F Series II (S/N: 2ZR1-UP)
- 990 (S/N: 7HK1-UP)
- 990 Series II (S/N: 4FR1-UP)
- 992G (S/N: 7HR1-UP)
- 992D (S/N: 7MJ1-UP)
- 994D (S/N: 3TZ1-UP)
- 826G (S/N: 7LN1-UP)
Reference: Special Instruction, SEHS9615, "Servicing DT Connectors"
Description of Change: The transmission direction rocker switches in Table 1 have been replaced by the new switches in Table 1. The STIC control (shift levers) in Table 2 have been replaced by the new STIC control (shift levers) in Table 2.
Show/hide table
Former Switch     | New Switch     |
---|---|
145-8673 159-8663     |
177-2373 177-2374     |
Show/hide table
Former STIC control (shift levers)     | New STIC control (shift levers)     |
---|---|
117-0298 136-1155 159-8661     |
177-4113     |
- Remove The Former Switch.
- Place the actuator in the NEUTRAL position.
- Use a small screwdriver in order to depress the tangs that are located on each end of the connector.
- Remove the actuator from the switch.
- Remove the screws that mount the transmission direction rocker switch onto the steering wheel.
- Remove the black ground wire from the switch's ground stud.
- Remove the purple wire and the gray wire from the connector. See Special Instruction, SEHS9615, "Servicing DT Connectors".
- Remove the transmission direction rocker switch from the assembly.
Show/hide table
Illustration 1 | g00670145 |
- Install The New Switch.
- Note the direction of the actuator on the new switch.
- Remove the actuator from the new switch.
- Apply 4C-4030 Thread Lock Compound to the two screws.
- Tighten the screws to 0.7 ± .2 N·m (6 ± 1.8 lb in).
- Reinstall the actuator on the switch.
- Install the gray wire, purple wire, and blue wire on the connector. See illustration 1.
- Apply 4C-4030 Thread Lock Compound to the ground post.
- Tighten the ground bolt to 1.7 ± 0.2 N·m (15 ± 1.8 lb in).
- Check for proper operation of the transmission direction rocker switch.
Adaptable To: The above changes are effective with Table 3.
Show/hide table
Sales Model     | Part Name     | Part Number     |
---|---|---|
515 (S/N: 4LR00728-UP) 525 (S/N: 1DN02013-UP) 545 (S/N: 2FZ00275-UP) 826G (S/N: 7LN00525-UP) 980G (S/N: 2KR03305-UP)     |
Transmission Direction Rocker Switch     | 177-2373     |
844 (S/N: 2KZ00305-UP) 854 (S/N: 1JW00244-UP) 988F II (S/N: 2ZR02050-UP) 990S II (S/N: 4FR00424-UP) 992G (S/N: 7HR00385-UP)     |
Transmission Direction Rocker Switch STIC control (shift lever)     |
177-2374 177-4113     |
Caterpillar Information System:
3412E Engine for Caterpillar Built Machines CID 0581 FMI 06 Power Shift Solenoid short to ground
3412E Engine for Caterpillar Built Machines CID 0581 FMI 05 Power Shift Solenoid open circuit
797 Off-Highway Truck Power Train Transmission Hydraulic Control - Disassemble
D350E Series II, D400E Series II and D400E Series II Ejector Articulated Trucks Braking System Pressure and Flow Compensator Valve (Brake) - Test and Adjust
D250E Series II and D300E Series II Articulated Trucks Operator's Compartment
D350E Series II, D400E Series II and D400E Series II Ejector Articulated Trucks Braking System Service Brake Air - Purge
Alternator - Delco 21SI Component Description
CB-535B Vibratory Compactor Steering System Wheel Tilt Hydraulic System
CB-535B Vibratory Compactor Steering System Gear Pump (Charge, Steering, Offset and Wheel Tilt)
784C, 785B, 785C, 785D, 789B, 789C, 789D, 793B, 793C, 793D, 797, and 797B Off-Highway Trucks Vital Information Management System (VIMS) General Information
3408E and 3412E Engines for Caterpillar Built Machines CID 0275 FMI 04 Right Turbo Inlet Pressure short to ground
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader CID 0274 FMI 04 Atmospheric Pressure short to ground
CS-431C, CP-433C and CS-433C Vibratory Compactors Vibratory System Support and Vibratory Drive
CP-433C, CS-431C and CS-433C Paving Compactors Engine Water Pump - Inspect
3500 Engines with EUI Option Cat Data Link
3500B and 3500B High Displacement Generator Set Engines Fuel Rate Scaling (Fuel Correction Factor) - Diesel Fuel
CB-535B Vibratory Compactor Ring Bearings - Lubricate
3500B Engines Fuel Injector Mechanism
CS-431C, CP-433C and CS-433C Vibratory Compactors Vibratory System Vibratory Support
CB-535B Vibratory Compactor Windows - Clean
3516B Generator Set Engines with Dynamic Gas Blending Aftercooler - Jacket Water Aftercooler
CB-535B Vibratory Compactor Window Wiper and Washer Control
2000/02/28 Serviceable Parts Are Available for the Swing Circuit Line Relief Valve {5454, 5480}
CB-535B Vibratory Compactor Window Wiper - Inspect/Replace