Storage
Usage:
If the engine is not started for several weeks, the lubricating oil drains from the cylinder walls and piston rings. This lack of oil permits the piston rings to rust; and causes metal-to-metal contact between the piston rings, the pistons and the cylinder liners when the engine is started. This metal-to-metal contact will result in shorter engine life. To prevent excessive engine wear:
- 1. Be sure all lubrication points mentioned in the LUBRICATION AND MAINTENANCE CHART are serviced.
- 2. Once a week, start and run the engine until it is thoroughly warm. For unattended automatic start-stop systems, an engine exerciser can be installed for this purpose.
- 3. Stop the engine, perform required servicing.
- 4. Check the cooling system for adequate protection against freezing if freezing temperatures can be expected. A 50-50 solution of permanent type antifreeze and approved water will give protection below -20°F (-29°C).
If it will be impossible to start the engine every week, see your Caterpillar dealer for instructions to prepare your engine for further storage.
Caterpillar Information System:
D353 INDUSTRIAL ENGINE Determining Cause Of Shutdown
D353 INDUSTRIAL ENGINE Testing Shutoff Devices And Alarms
D353 INDUSTRIAL ENGINE Emergency Shutoff Devices And Alarms
D353 INDUSTRIAL ENGINE Emergency Stopping
D353 INDUSTRIAL ENGINE Woodward Governors
D353 INDUSTRIAL ENGINE Engine Operation
D353 INDUSTRIAL ENGINE Automatic Start-Stop
D353 INDUSTRIAL ENGINE General
D353 INDUSTRIAL ENGINE Foreword
D330, D333, D334, D336 INDUSTRIAL & MARINE ENGINE Miscellaneous Maintenance
D330, D333, D334, D336 INDUSTRIAL & MARINE ENGINE Power Coupling System
D330, D333, D334, D336 INDUSTRIAL & MARINE ENGINE Electrical System
D353 INDUSTRIAL ENGINE Foreword
D353 INDUSTRIAL ENGINE Model Views
D353 INDUSTRIAL ENGINE Generator Identification
D353 INDUSTRIAL ENGINE Generator Lead Connections
D353 INDUSTRIAL ENGINE Generator Performance
D353 INDUSTRIAL ENGINE Generator Set Control Panel (If Equipped)
D353 INDUSTRIAL ENGINE Single Unit Operation
D353 INDUSTRIAL ENGINE Parallel Operation
D353 INDUSTRIAL ENGINE Generator Lubrication and Maintenance
D353 INDUSTRIAL ENGINE D353 Industrial Engine46B2437-Up
D353 INDUSTRIAL ENGINE Engine Lubrication System
D353 INDUSTRIAL ENGINE Air Induction And Exhaust System