Transfer Gears - Assemble
Show/hide table
所需工具 | |||
---|---|---|---|
工具 | 零件号 | 零件说明 | 数量 |
A | 8T-5096 | 千分表总成 | 1 |
A | 6V-6042 | 1 | |
B | 1P-0510 | 起子总成 | 1 |
- 检查所有 O 形密封圈和部件有无磨损或损坏。 如有必要,请更换部件。
- 利用所密封的润滑剂轻轻润滑所有 O 形密封圈。
Show/hide table
图 1 g00564845 - 将滚柱轴承外圈 (22) 冷却至温度为
−75 °C (−103 °F) 。 将滚柱轴承外圈 (22) 安装到分动器壳体中。Show/hide table图 2 g00564896 - 将两个滚柱轴承内圈 (21) 加热至最高温度
135 °C (275 °F) 。 将两个滚柱轴承内圈 (21) 安装到分动器 (20) 上。 - 将分动器 (20) 安置到分动器壳体上。
Show/hide table
图 3 g00564898 - 将滚柱轴承内圈 (18) 冷却至温度为
−75 °C (−103 °F) 。 将滚柱轴承外圈 (18) 安装到轴承保持架 (16) 中。Show/hide table图 4 g00564903 - 将原有垫片、轴承罩 (16) 和螺栓 5 安装到分动器壳体上。 安装将轴承罩 (16) 固定在分动器壳体上的 13 只螺栓和垫圈。 拧紧螺栓至扭矩为
50 ± 10 N·m (37 ± 7.4 lb ft) 。 - 使用工具 (A) 测量滚柱轴承内圈 (21) 的端隙。 增加或减少轴承罩 (16) 与分动器壳体之间的垫片,以便使轴向间隙测量值达到
0.15 ± 0.05 mm (0.006 ± 0.002 in) 。Show/hide table图 5 g00564699 - 将管组件 (13) 安置到分动器壳体上并连接管组件 (13)。
- 安装将管组件 (13) 固定在分动器壳体上的螺栓 (14)。 将夹子 (15) 朝与螺栓 (14) 头部相反的方向弯曲。
Show/hide table
图 6 g00564905 - 将两个滚柱轴承内圈 (12) 加热至最高温度
135 °C (275 °F) 。 将两个滚柱轴承内圈 (12) 安装到分动器 (9) 上。Show/hide table图 7 g00564907 - 将弹簧销和护圈组件 (11) 安装到分动器 (9) 上。
- 将挡圈 (10) 安装到分动器 (9) 上。
Show/hide table
图 8 g00564584 - 将分动器 (9) 安装到分动器壳体上。
Show/hide table
图 9 g00564908 - 将 7M-7260 液体密封垫涂敷在分动器壳体中的密封孔上,并让 液体密封垫晾干。
注: 请勿将 7M-7260 液体密封垫涂抹在唇形密封上。
- 使用工具 (B) 将唇形密封安装到轴承罩 (4) 上。 用润滑剂稍微润滑要密封的唇形密封的密封唇。
Show/hide table
图 10 g00564909 - 将滚柱轴承内圈 (6) 冷却至温度为
−75 °C (−103 °F) 。 将滚柱轴承外圈 (6) 安装到轴承罩 (4) 上。 - 将 O 形密封圈 (8) 安装到轴承罩 (4) 上。
Show/hide table
图 11 g00564910 - 用润滑剂稍微润滑要密封的分动器壳体的孔。 将原有垫片、轴承罩 (4) 和螺栓 5 安装到分动器壳体上。 安装将轴承罩 (4) 固定在分动器壳体上的 11 只螺栓 (1)、垫圈和隔套。 拧紧螺栓 (1) 至扭矩为
50 ± 10 N·m (37 ± 7.4 lb ft) 。 - 使用工具 (A) 测量滚柱轴承内圈 (12) 的端隙。 增加或减少轴承罩 (4) 与分动器壳体之间的垫片,以便使轴向间隙测量值达到
0.15 ± 0.05 mm (0.006 ± 0.002 in) 。Show/hide table图 12 g00564533 - 将轭 (3)、12 角头螺栓 (2) 和硬垫圈安装到分动器上。 拧紧 12 角头螺栓 (2) 至扭矩为
270 ± 25 N·m (200 ± 18 lb ft) 。
结束:
- 安装变速箱转速传感器。 请参阅拆解和组装, "变速箱转速传感器 - 安装"。
- 连接变速箱行星齿轮和分动器。 请参阅拆解和组装, "变速箱行星齿轮和分动器 - 连接"。
Caterpillar Information System:
3512B and 3516B Engine Supplement for and 784C,, 785C and and 785C HAA Off-Highway Truck/Tractors Accessory Drive (Front) - Install
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Electronic Systems F336 Fuel Pull-In Relay - Low Current
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Machine Systems Steering Pump - Assemble
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Electronic Systems F335 Steering Reverse Solenoid - Low Current
Challenger 65E, Challenger 75E, Challenger 85E and Challenger 95E Agricultural Tractors Power Train Transmission Hydraulic Control Operation
Flexxaire Fan Caterpillar Reference Material (Flexxaire Fan)
AP-1055B and BG-2455C Asphalt Pavers Speedometer and Machine Hour Meter
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Electronic Systems F334 PTO Solenoid - Low Current
D400E Series II Articulated Truck Steering Check and Combiner Valve - Install
D350E Series II Articulated Truck Steering Check and Combiner Valve - Remove
216, 226 and 228 Skid Steer Loaders Engine Supplement Water Pump - Remove and Install
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Electronic Systems F333 Fuel Hold-In Solenoid - Low Current
D400E Series II Articulated Truck Accumulator (Suspension) - Remove and Install
554 Forwarder and 574 Forwarder Cab Tilt Hydraulic System Oil Level - Check
3524B Engine for Caterpillar Built Machines Accessory Drive (Rear) - Remove
AP-1000B and BG-260C Asphalt Pavers Parking Brake Control
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Electronic Systems F338 CCM Sensor 5 Volt Supply - Failed Low
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Electronic Systems F339 CCM Sensor 5 Volt Supply - Failed High
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Electronic Systems Diagnostic Operation
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Electronic Systems F340 Transmission Speed Sensor - Failed High
Electric Protection System Energize-To-Run For Generator Set, Industrial and Marine Diesel Engines Oil Step Speed Calibration
CB-534C and CB-634C Vibratory Compactors Vibratory System Visual Inspection
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Electronic Systems F341 Transmission Speed Sensor - Failed Low
797 Off-Highway Truck Power Train Gear Pump (Transmission Charging and Scavenge)