Usage:
a. Put liquid soap on cylinder block liner bore surfaces and rubber seals on the lower part of the liner.
b. Put the filler band completely in clean engine oil for a moment.
c. Install filler band (3) in the groove under the liner flange, without delay.
d. Install the liner in the bore immediately, before expansion of the filler band.
(1)
Bore in liner (new) ... 5.401 ± .001 in.(137.19 ± 0.03 mm)
Maximum permissible bore when measured near upper end of the wear surface of the cylinder liner (worn) ... 5.408 in.(137.36 mm)
"Use again" maximum bore (when measured near upper end of the wear surface of the cylinder liner) ... 5.405 in.(137.29 mm)
(2) Thickness of flange on liner ... .3500 ± .0008 in.(8.890 ± 0.020 mm)
(3) Filler Band.
NOTE: Make reference to GUIDELINE FOR REUSABLE PARTS; PISTONS AND CYLINDER LINERS, FORM NO. SEBF8001.