Usage:
1. Raise the rear of the machine with a 50 ton screw jack until the tires and rims to be removed are off the ground.
2. Remove the nuts that hold valve groups (4) to plate (3). Remove plate (3) and the spacer from ring (2).
3. The weight of the tire and rim is 3051 kg (6730 lb). Fasten a hoist on a lift truck to the tire and rim.
4. Remove nuts (1) and the washers. Remove the tire and rim from the machine. Use a hoist, and remove ring (2) from the rim if necessary. The weight of the ring is 96 kg (212 lb).
5. Remove guards (5) from the inner rear tire and rim.
6. Remove guard (6) from the wheel.
7. Release the pressure from the inside rear tire. Remove hose (7) and the clip from the wheel and rim.
8. The weight of the tire and rim is 3051 kg (6730 lb). Fasten a hoist on a lift truck to the tire and rim.
9. Remove nuts (8) and the washers. Remove the tire and rim from the machine.
10. Remove any studs that are loose or damaged.
Install Rear Tires & Rims
1. If any of the studs were removed from the wheel, install the studs, and tighten them to a torque of 350 ± 40 N·m (260 ± 30 lb ft).
| NOTICE |
|---|
Make sure the rim and wheel mounting surfaces are clean and free of grease, paint, nicks, burrs, etc. Make sure the threads of the studs and nuts are clean and dry. |
2. Align the valve stem hole in the rim with the four bolt holes in the wheel for guard (1). Put the tire and rim in position on the wheel, and install the washers and nuts (3) that hold it. Tighten the nuts to a torque of 1125 ± 100 N·m (820 ± 75 lb ft).
3. Install hose (2) guard (1) and the clip for hose (2) as shown.
4. Install guards (4) on the inner rear rim.
5. If ring (5) was removed, install the studs in the ring, and tighten them to a torque of 350 ± 40 N·m (260 ± 30 lb ft)
| NOTICE |
|---|
Make sure the mounting surfaces of the rim and ring are clean and free of grease, paint, nicks, burrs, etc. Make sure the threads of the studs and nuts are clean and dry. |
6. Put ring (5) in position on the rim with the notch in alignment with the valve stem. Install the washers and nuts to hold the ring, and tighten them to a torque of 1125 ± 100 N·m (820 ± 75 lb ft)
| NOTICE |
|---|
Make sure the ring and wheel mounting surfaces are clean and free of grease, paint, nicks, burrs, etc. Make sure the threads of the studs and nuts are clean and dry. |
7. Align the valve stems of the inner and outer rear tires and rims, and put the outer rear tire and rim in position on the wheel. Install the washers and nuts (6) to hold the tire and rim, and tighten them to a torque of 1125 ± 100 N·m (820 ± 75 lb ft)
8. Put the two spacers and plate (7) in position on ring (5), and install the bolts and washers to hold them.
9. Install the nuts that hold valve groups (8) in position on plate (7).
10. Fill the rear tires with nitrogen to the proper pressure. See the Maintenance Guide for the proper fill pressure.
11. Lower the machine to the ground, and remove the screw jack.