Engine Crankshaft Vibration Damper Counter - Reset
Use this procedure to reset the counter for vibration damper.
- Connect Cat® Electronic Technician (ET), release 2018B or newer.
- Select the "Service" tab in Cat ET.
- Click "Engine Crankshaft Damper Replacement".
Show/hide tableIllustration 1 g06367833 - Make sure that the engine is not running.
Show/hide table
Illustration 2 g06367846 - Click the rest at the bottom of the screen. As shown in Illustration 2.
Show/hide table
Illustration 3 g06367820 - Verify that the reset worked by reviewing the value column reading is 0. As shown in Illustration 3.
If the procedure did not correct the issue, contact your Cat Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solution Network (DSN).
Caterpillar Information System:
G3500H 60Hz Generator Sets Engine Oil Sample - Obtain
G3500H 60Hz Generator Sets Coolant Sample (Level 1) - Obtain
G3512 Generator Set Engine Camshaft Speed Sensor - Remove and Install
C175 Petroleum Engine Aftertreatment SCR System - Decommission
C175 Petroleum Engine Valve Lash - Adjust - Hydraulic Lash Adjusters
C175 Petroleum Engine Fuel Rail Pressure - Release
C175 Petroleum Engine Fuel System Inspection
C175 Petroleum Engine Cooling System Operation
C175 Petroleum Engine Valve Mechanism - Hydraulic Lash Adjusters
3512C and 3512E Engines Engine Idle Reduction System Sensor Supply - Test
G3500H 60Hz Generator Sets Engine Oil Level - Check
C175-16 Petroleum Engines Fuel Pump (High Pressure) - Remove and Install
G3512 Generator Set Engine Crankshaft Speed Sensor - Remove and Install
Rework Procedure for Exhaust Rain Cap and Insulation on Certain XQ200 Generator Sets {1072} Rework Procedure for Exhaust Rain Cap and Insulation on Certain XQ200 Generator Sets {1072}
Installation of New Shift Lever Assembly for All Starter Motors {1453} Installation of New Shift Lever Assembly for All Starter Motors {1453}
Procedure to Install the Insulator on to Series Starters on All Engines {1453} Procedure to Install the Insulator on to Series Starters on All Engines {1453}
Installation of Repair Kit-Solenoid Plunger Assembly on All Engines {1453} Installation of Repair Kit-Solenoid Plunger Assembly on All Engines {1453}
Procedure to Install Terminal Kit on All Engines {1453} Procedure to Install Terminal Kit on All Engines {1453}
Procedure to Install Brush Holder Assembly in All Engines {1453} Procedure to Install Brush Holder Assembly in All Engines {1453}
Procedure for Replacing Regulator Kit on All Engines {1405} Procedure for Replacing Regulator Kit on All Engines {1405}
Procedure to Install Brush Holder Assembly to End Frame on All Engines {1405} Procedure to Install Brush Holder Assembly to End Frame on All Engines {1405}
Perform Circuit Breaker Inspection on Certain Cat® Engines {1420} Perform Circuit Breaker Inspection on Certain Cat® Engines {1420}
New Firmware is Available for Certain Power Modules {7610} New Firmware is Available for Certain Power Modules {7610}
New Engine and Aftertreatment Software are Now Available for Certain 797F Off-Highway Truck Engines {1920, 7620} New Engine and Aftertreatment Software are Now Available for Certain 797F Off-Highway Truck Engines {1920, 7620}