Pressure Sensor (DPF) - Remove and Install
- Disconnect harness assemblies (3).
- Remove tube assembly (1) and tube assembly (4).
- Remove pressure sensor assembly (2).
Show/hide table
Illustration 2 g03783454 - Remove bracket (6). Remove catalytic converter pressure sensor (5) and the O-ring seals.
- Remove pressure sensor (DPF) (10) and the O-ring seals.
- Remove adapters (8) and the O-ring seals.
- Remove manifold (9) from plate (7).
Show/hide table
Illustration 1 | g03783414 |
- Install pressure sensor assembly (2) in the reverse order of removal.
- Tighten pressure sensor (DPF) (10) to a torque of
10 ± 2 N·m (89 ± 18 lb in) .
Note: Do not pre-tighten the sensor using the plastic portion of the sensor. Pre-tighten the sensor using the metal hex portion of the sensor. Damage can occur to the sensor if pre-tightened using the plastic portion of the sensor.
- Tighten pressure sensor (DPF) (10) to a torque of
Caterpillar Information System:
Turbine Blades May Shift In Certain C280 And 3600 Engine ABB Turbochargers{1052} Turbine Blades May Shift In Certain C280 And 3600 Engine ABB Turbochargers{1052}
C13 Generator Set Engine Temperature Sensor (Catalyst Inlet) - Remove and Install
Final Drive Motor Housings Are Available for Certain Excavators {4050} Final Drive Motor Housings Are Available for Certain Excavators {4050}
3516B Generator Set Engines with Dynamic Gas Blending Fuel Pressure Is Low
C13 Generator Set Engine Temperature Sensor (DPF Inlet, Flame Detect) - Remove and Install
C280 Marine Engines Fuel Pressure Is High
C13 Generator Set Engine Pressure Sensor (ARD Combustion Air) - Remove and Install
C4.4 and C6.6 Engines Crankcase Breather Ejects Oil
Procedure for Installing Three Phase Flywheel Inverter On Certain Uninterruptible Power Supply{4480} Procedure for Installing Three Phase Flywheel Inverter On Certain Uninterruptible Power Supply{4480}
C13 Generator Set Engine Fuel Temperature Sensor - Remove and Install
C13 Generator Set Engine Fuel Pressure Sensor - Remove and Install
C13 Generator Set Engine Crankcase Pressure Sensor - Remove and Install
C13 Generator Set Engine Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
C2.2 Engines for Caterpillar Built Machines Crankshaft
C13 Generator Set Engine Pressure Sensor (Cooled Exhaust Gas) - Remove and Install
C13 Generator Set Engine Pressure Sensor (NRS Differential) - Remove and Install
C13 Generator Set Engine Pressure Sensor (NRS Absolute) - Remove and Install
2015/05/15 A New Starter Is Now Available for Certain Cat® Generator Set Engines {1453}
C13 Generator Set Engine Boost Pressure Sensor - Remove and Install
C13 Generator Set Engine Inlet Air Temperature Sensor - Remove and Install
3516B Generator Set Engines with Dynamic Gas Blending Component Location
C13 Generator Set Engine Venturi Tube - Remove and Install
C7.1 Engines Aftertreatment Identification Module - Test
C2.2 Engines for Caterpillar Built Machines Piston and Rings