Atmospheric Pressure Sensor - Remove and Install
- Disconnect harness assembly (1) and remove atmospheric pressure sensor (2).
Show/hide table
Illustration 1 | g03772788 |
- Install atmospheric pressure sensor (2) in the reverse order of removal.
- Tighten atmospheric pressure sensor (2) to a torque of
10 ± 2 N·m (89 ± 18 lb in) .
Note: Do not pre-tighten the atmospheric pressure sensor using the plastic portion of the atmospheric pressure sensor. Pre-tighten the atmospheric pressure sensor using the metal hex portion of the atmospheric pressure sensor. Damage can occur to the atmospheric pressure sensor if pre-tightened using the plastic portion of the atmospheric pressure sensor.
- Tighten atmospheric pressure sensor (2) to a torque of
Caterpillar Information System:
XQ375 and XQ425 Rental Generator Sets Product Lifting
C3.4B Engines Indicator Lamp - Test
XQ375 and XQ425 Rental Generator Sets Plate Locations and Film Locations
C7.1 Engines Engine Shutdown Occurrence
Caterpillar Petroleum Well Service Transmission Installation Appraisal Procedures{1400, 3030} Caterpillar Petroleum Well Service Transmission Installation Appraisal Procedures{1400, 3030}
2014/12/19 New Tube Assemblies Are Used on Certain G3600 Engines {1070, 1350}
2014/12/12 An Improved Wiring Harness Is Used on Certain G3600 Engines {1408}
Engine Speed May Elevate Unexpectedly on Certain Commercial Engines{1920} Engine Speed May Elevate Unexpectedly on Certain Commercial Engines{1920}
XQC1200 Power Module Engine Air Cleaner Service Indicator - Inspect
464-0265 Lifting Bracket Assembly{0374, 0599, 0629, 0632, 0700, 0708, 1353} 464-0265 Lifting Bracket Assembly{0374, 0599, 0629, 0632, 0700, 0708, 1353}
C13 Industrial Engine Fumes Disposal Filter Element - Replace - If Equipped
C13 Generator Set Engine Nitrogen Oxide Sensor - Remove and Install
2014/12/19 New Differential Pressure Lines Routing Is Used For All C9.3 to C18 Tier 4 Interim Industrial Engines {108D}
C13 Generator Set Engine Camshaft Position Sensor - Remove and Install
C13 Generator Set Engine Crankshaft Position Sensor - Remove and Install
C7 Marine Engine Maintenance Interval Schedule - High Performance
C280 Marine Engines Exhaust System Contains Oil
C7 Marine Engine Maintenance Interval Schedule - Commercial Ratings
2015/01/06 Event Codes (E2131, E2132, or E2133) Appearing Occasionally with On-board Machine Systems with a PL321, or PL121 Satellite System Installed {7600, 7606}
C13 Generator Set Engine Coolant Temperature Sensor - Remove and Install
C9 Marine Engines Overhaul (Major)
C4.4 and C6.6 Engines Engine Overcrank Occurrence
C7.1 Engines Engine Shutdown Occurs Intermittently
C7.1 Engines Engine Stalls at Low RPM