Injector (Diesel Exhaust Fluid) - Replace
Show/hide table
Illustration 1 | g03363165 |
Typical example shown |
- Remove the diesel exhaust fluid (DEF) line (1) from the injector (4).
- Remove the coolant lines (2) from the injector.
- Remove the electrical connector (3) from the injector.
- Remove the bolts from the injector and remove the injector.
- Replace gasket. The steel side of the gasket should face towards diesel particulate filter (DPF) outlet.
- Replace the injector.
- Apply anti-seize to bolt threads.
- Torque the bolts of the injector to
5 N·m (3.7 lb ft) . Retighten all bolts to5 N·m (3.7 lb ft) , then turn 90°. - Connect the electrical connector.
- Connect the coolant lines.
- Connect the DEF line.
Caterpillar Information System:
3512C Petroleum Engines Electronic Control Module (Engine) - Remove and Install
2014/01/17 Special Instructions Are Available for Retrofitting the Dynamic Gas Blending Kits on Certain 3512B Engines {1250, 1280}
2013/10/17 A New Expansion Tank Assembly Is Used on Certain 3500 Marine Engines {1354}
C7.1 Industrial Engine Manifold (DEF Heater) - Remove and Install
C7.1 Industrial Engine Solenoid Valve (DEF Heater Coolant) - Remove and Install
3516C Petroleum Engines Engine Oil Pressure Sensor - Remove and Install
3512E HD Petroleum Engine Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace - If Equipped
3512C Oil Well Service Engines Declaration of Conformity
435-8503 Major Engine Overhaul Foundational Kit for 3406E Marine Engines{1000} 435-8503 Major Engine Overhaul Foundational Kit for 3406E Marine Engines{1000}
3516C Petroleum Engines Engine Speed/Timing Sensor - Remove and Install
Installation of the 384-9286 Protection Cover Gp for Certain Clean Emissions Module Arrangements{108D, 795C} Installation of the 384-9286 Protection Cover Gp for Certain Clean Emissions Module Arrangements{108D, 795C}
3512E Engines for Well Stimulation Pumps Cover Group (Front Housing)
C15 and C18 Engines for Caterpillar Built Machines Fuel Filter and Water Separator
C7.1 Industrial Engine Diesel Exhaust Fluid Module - Disassemble
C7.1 Industrial Engine Diesel Exhaust Fluid Module - Assemble
2013/11/21 A New Jacket Water Outlet Elbow Is Used on Certain C175 Marine and Petroleum Engines {1380}
3512C Petroleum Engines Gas Pressure Regulator - Remove and Install
C7.1 Engines NOx Conversion Is Low
3512C Petroleum Engines Fuel Control Actuator - Remove and Install - Dynamic Gas Blending
C32 Auxiliary Engine Engine Electronics
2013/07/25 A New Coupling Assembly Is Used on Heat Exchangers for Certain 3500B and 3500C Engines {1379}
2013/07/25 New Software Flash File Extension Requires Caterpillar Electronic Technician (Cat ET) 2013B {0785, 7620}
349F and 352F Excavators Hydraulic System Solenoid Valve (Proportional Reducing) - Power Shift System
349F and 352F Excavators Hydraulic System Relief Valve (Main) - Heavy Lift