3512C HD Locomotive Engine Caterpillar


Fuel Injector - Inspect/Adjust

Usage:

3512C NJT
Note: Perform this procedure when the engine valve lash is inspected.

------ WARNING! ------

The Electronic Control Module produces high voltage. To prevent personal injury make sure the Electronic Control Module is not powered and the unit injector solenoids are disconnected.

----------------------


NOTICE

The camshafts must be correctly timed with the crankshaft before an adjustment of the lash for the fuel injector is made. The timing pins must be removed from the camshafts before the crankshaft is turned or damage to the cylinder block will be the result.


Inspect the adjustment of the lash for the fuel injector according to the Systems Operation/Testing And Adjusting, UENR0519, "Fuel Injector Adjustment" topic. Adjust the lash for the fuel injector, if necessary.

Caterpillar Information System:

Gas Compression Operator Control Panel Electronic Control Module (Control Panel)
Gas Compression Operator Control Panel Abbreviations
C18 Generator Sets Grounding Stud - Inspect/Clean/Tighten
C175-16 Locomotive Engine Electronic Service Tool Does Not Communicate
C175-16 Marine Propulsion Engines Thermocouple
C3.4B Engines Crankcase Breather Ejects Oil
C175-16 Marine Propulsion Engines Turbocharger Oil Lines
C175-16 Marine Propulsion Engines Thermocouple
C175-16 Marine Propulsion Engines Vibration Damper Guard
C175-16 Marine Propulsion Engines Vibration Damper Guard
C175-16 Marine Propulsion Engines Vibration Damper Guard
3500E Marine Engines Control Panel - Marine Classification Society Control Panel (MCS Control Panel) (If Equipped)
C3.8 Engines for Caterpillar Built Machines Electrical System
3516B Generator Set Engines with Dynamic Gas Blending Symptom Troubleshooting
3512B, 3512C, and 3516B Petroleum Engines and Petroleum Generator Set Engines with Dynamic Gas Blending Oil Contains Fuel
C175-16 Locomotive Engine Exhaust Has Excessive Black Smoke
3512B and 3512C Petroleum Generator Set Engines ECM Software - Install
C175-16 Locomotive Engines Thermostatic Valve - Inspect
C18 Generator Sets Engine Speed/Timing Sensor - Clean/Inspect
C18 Generator Sets Engine Valve Lash - Check
C175-16 Locomotive Engine Flywheel Housing
C175-16 Marine Propulsion Engines Air Cleaner
C175-16 Marine Propulsion Engines Turbocharger
C175-16 Marine Propulsion Engines Coolant Temperature Control Module - Test
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.