Flywheel Housing - Inspect
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件描述     | 数量     |
A     | 8T-5096     | 千分表总成     | 1     |
飞轮壳体同轴度
注: 本项检查必须在已拆卸飞轮和起动马达并稍微拧紧飞轮壳体螺栓的情况下进行。
- 安装工具 (A) 。 请参阅图 1。
Show/hide table
图 1 | g01344313 |
典型示例 |
- 将千分表指针设在 0 mm (0 in)。
- 绕飞轮壳体每隔 45 度检查同轴度。
- 计算最小测量值与最大测量值之间的差值。 这个差值不能高于表 2 中给出的极限值。
飞轮壳体直线度
注: 本项检查必须在已拆卸飞轮和起动马达并以正确扭矩拧紧飞轮壳体螺栓的情况下进行。
Show/hide table
图 2 | g01344315 |
典型示例 |
- 安装工具 (A) 。 请参阅图 2。
- 将千分表指针设在 0 mm (0 in)。
- 绕飞轮壳体每隔 45 度检查直线度。
- 计算最小测量值与最大测量值之间的差值。 这个差值不能高于表 2 中给出的极限值。
Show/hide table
表 2 飞轮壳体跳动量和直线度极限值(千分表总读数)     壳体法兰孔     最大极限值(千分表总读数)    
410 mm (16.14 in)    
0.25 mm (0.010")    
448 mm (17.63 in)    
0.28 mm (0.011 in)    
Caterpillar Information System:
C3.4B Engines for Caterpillar Built Machines Flywheel - Inspect
C3.4B Engines for Caterpillar Built Machines Turbocharger - Inspect
3500C Marine Engines Fuel Injector Mechanism
C7 Engines for Caterpillar Built Machines Camshaft
UPSB125 Uninterruptible Power Supply UPS Battery - 50Hz Configuration - Check
UPSB125 Uninterruptible Power Supply UPS Battery - 50Hz Troubleshooting
C9 Industrial Engines Refill Capacities
Vane Type Hydraulic Pump Identification Guidelines {5055} Vane Type Hydraulic Pump Identification Guidelines {5055}
2011/05/25 New Software Is Available for Certain C13 Industrial Engines {1901, 1920}
390F Excavator Machine System Bucket Linkage
C7 Engines for Caterpillar Built Machines Valve Mechanism
C9 Industrial Engines Fuel System - Prime
C3.4B Engines for Caterpillar Built Machines V-Belt - Test
C3.4B Engines for Caterpillar Built Machines Fuel System - Prime
C3.4B Engines for Caterpillar Built Machines Piston Height - Inspect
2011/05/12 New Software Is Now Released for Product Link PL522/523 Systems On All Cat Product {7606}
2011/07/18 New Pressure Switch Is Now Used For Air Conditioner Refrigerant On Certain Cat Products {1435, 1809}
2012/01/16 Special Instruction, REHS7131 , "Procedure for the Installation of the 372-1187 Nitrogen Oxide Sensor Gp and the 379-0138 Sensor Kit (NITROGEN OXIDE)" Is Available {1408, 1439, 191N, 7400}
DPF Temperature Sensor Thread Salvage Procedure for Certain C7 thru C15 On-Highway Engines{108F, 1439, 1919, 7400} DPF Temperature Sensor Thread Salvage Procedure for Certain C7 thru C15 On-Highway Engines{108F, 1439, 1919, 7400}
C9 Industrial Engines Configuration Parameters
C9 Industrial Engines Aftercooler Core - Inspect/Clean/Test
Cat® Alarm and Protection System Control Panel Overview (RP 410)
C9.3 Engine for Caterpillar Built Machines Water Pump
3500B and 3500C Marine Engines Camshaft