Engine Crankcase Breather - Clean
Show/hide table
Illustration 1 | g02159418 |
The crankcase breathers are located on the valve covers.
- Remove the tube (1) from the outlet of the breather and loosen the clamp.
- Remove the breather from the engine.
- Check the condition of the seal. Replace the seal if the seal is damaged.
- Remove the breather element. Wash the breather element and wash the breather in a clean nonflammable solvent.
- Shake the breather element until the breather element is dry. You may also use pressurized air in order to dry the breather element.
- Check the condition of the tube. Replace the tube if the tube is damaged.
- Install the element into the breather and install the breather.
- Install the tube onto the outlet of the breather cover and tighten the clamp.
Caterpillar Information System:
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Control Panel - Inspect/Test
C27 and C32 Tier 4 Engines Speed/Timing - Test
Procedure to Salvage Tang Slots on Transmission and Brake Pistons {0679, 3160, 4011, 4251} Procedure to Salvage Tang Slots on Transmission and Brake Pistons {0679, 3160, 4011, 4251}
C27 Industrial Engine and C27 Locomotive Engine Fuel and the Effect from Cold Weather
C27 and C32 Tier 4 Engines Exhaust Balance Valve - Test
G3520C and G3520E Engines Actuator Linkage
C27 Petroleum Engine Cold Weather Starting
C15 Petroleum Generator Set Product Lifting
2010/07/14 A New Throttle Group Is Used on Certain G3516B Engines {1265, 1269}
C18 Marine Engine Zinc Rods - Inspect/Replace
C27 and C32 Tier 4 Engines Sensor Signal (Analog, Passive) - Test
C18 Marine Engine Fuel System Secondary Filter - Replace
2010/05/31 Correct Cylinder Head Options Are Now Used for Certain 3412 and 3412C Marine Engines {1102, 1121, 1123, 1209}
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Belts - Inspect/Adjust/Replace
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Space Heater - Test
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Cold Weather Starting
C7.1 Industrial Engine and Generator Set NRS Mass Flow Rate Problem
Hazardous Area Shift Selector Application and Installation Guide for Petroleum Transmissions{3065, 7490} Hazardous Area Shift Selector Application and Installation Guide for Petroleum Transmissions{3065, 7490}
C27 and C32 Tier 4 Engines Diagnostic Trouble Codes
C18 Marine Engine Closed Crankcase Ventilation (CCV) Fumes Disposal Filter - Replace
XQ Auto Paralleling General Maintenance Information
C27 and C32 Tier 4 Engines Engine Monitoring Parameters
G3304B and G3306B Engines Catalytic Converter
2010/06/10 Improvements Have Been Made to Remanufactured Fuel Injectors on C15 and 3406E Engines {1251, 1290}