Air Filter Element (Inverter Cabinet) - Clean/Replace - Metal Sand Filters
- 拆下滤清器支架 (1) 。
Show/hide table
图 1 | g01804336 |
- 从变频器柜中拆下空气滤清器滤芯 (2) 。
- 清洁空气滤清器滤芯,直到光线均匀透过滤清器。
- 将滤清器放到坚实的平面上,并利用水压清洗器清洁滤清器。
注: 高水压可损坏滤清器。 必要时,通过降低水压或使水枪保持较大距离来防止损坏滤清器。
- 将空气滤清器滤芯完全晾干。
- 将滤清器放到坚实的平面上,并利用水压清洗器清洁滤清器。
- 安装干净的空气滤清器滤芯。 安装滤清器支架。
注: 检查空气滤清器滤芯有无损坏。 更换任何损坏的空气滤清器滤芯。
注: 不要在物体上敲打滤清器。 不要使用化学品清洗滤清器。
- 对变频器柜中的 7 个空气滤清器滤芯中的每个重复步骤 2 到步骤 5。
Caterpillar Information System:
2009/02/02 Shims Are Now Used in the Carburetors of G3516 Engines {1266}
3512B Generator Set Engine Diagnostic Trouble Codes
CX31-P600 Petroleum Transmission Well Servicing Relief Valve (Torque Converter Inlet) - Remove and Install
2009/02/02 A New Seal Is Used for the Ignition Transformers inG3600 Engines {1550, 7555}
2009/02/01 A New Connecting Rod Bearing is Available {1218, 1219, 1225}
2009/02/16 New Rocker Arms Are Available {1123}
C9 Marine Engines and C9 Marine Generator Sets Flexible Coupling
C9 Marine Engines and C9 Marine Generator Sets Drive Shaft
C18 Industrial Engine Fuel System
349F and 352F Excavators Machine System Specifications Relief Valve (Negative Flow Control)
C18 Fire Pump Engine Safety Messages
C18 Industrial Engine Inlet Manifold Pressure - Test
2009/02/16 Disposable Paper Air Filters Require Protection {1051, 1054}
345D, 349D and 349D2 Excavators and 345D MHPU, 349D MHPU and 349D2 MHPU Mobile Hydraulic Power Units Machine Electronic Control System MID 039 - CID 0588 - FMI 12
345D, 349D and 349D2 Excavators and 345D MHPU, 349D MHPU and 349D2 MHPU Mobile Hydraulic Power Units Machine Electronic Control System MID 039 - CID 0588 - FMI 09
CX35-P800 Petroleum Transmission and Petroleum Power Train Packages Pump Drive - Remove
CX35-P800 Petroleum Transmission and Petroleum Power Train Packages Pump Drive - Install
345D, 349D and 349D2 Excavators and 345D MHPU, 349D MHPU and 349D2 MHPU Mobile Hydraulic Power Units Machine Electronic Control System MID 039 - CID 0600 - FMI 04
2009/02/02 A New Rocker Arm Assembly is Available {1123}
2011/09/12 A New Rocker Arm Assembly Is Available {1123}
2009/03/02 Pressure Requirements for the Fuel Supply of the C175 Engine {1250}
2009/02/09 Improvement to the Oil Pressure Switch {7400, 7421}
2009/03/30 Introduction of a New Fuel Filter Base {1260, 1261}
CX35-P800 Petroleum Transmission and Petroleum Power Train Packages Pump Drive - Disassemble