Clean Emissions Module - Remove and Install
Show/hide table
Hot engine components can cause injury from burns. Before performing maintenance on the engine, allow the engine and the components to cool. |
Show/hide table
Wear goggles, gloves, protective clothing, and a National Institute for Occupational Safety and Health (NIOSH) approved P95 or N95 half-face respirator when handling a used Diesel Particulate Filter or Catalytic Converter Muffler. Failure to do so could result in personal injury. |
- Disconnect all electrical and Diesel Exhaust Fluid (DEF) connections to the clean emissions module.
Show/hide table
Illustration 1 g06303038 - Remove bolts (2) and DEF injector (1).
Show/hide table
Illustration 2 g06303029 - Attach eyebolts (3) and a suitable lifting device to the clean emissions module. The weight of the module is approximately
975 kg (2150 lb) .Note: Eyebolts (3) are shipped with the clean emissions module and removed during installation.
- Remove exhaust insulation (4) and (5).
Show/hide table
Illustration 3 g06303044 - Remove clamps (8) and mounting groups (7).
- Remove clean emissions module (6).
- Install clean emissions module (6) in the reverse order of removal.
Note: Eyebolts (3) must be removed after the installation of the clean emissions module.
Caterpillar Information System:
CX48–P2560–3060 Petroleum Transmission Speed Sensor (Transmission)
CX48–P2560–3060 Petroleum Transmission Relief Valve (Transmission Lubrication)
Fuse Installation Procedure for Product Link PL631 on Certain 950 GC Medium Wheel Loaders {1417, 7606} Fuse Installation Procedure for Product Link PL631 on Certain 950 GC Medium Wheel Loaders {1417, 7606}
986K Wheel Loader Systems Rear View Mirror
New Operator Monitor Group Is Now Used on Certain D5R, D6K, D6N, D6T, D8R, and D8T Track-Type Tractors {1408, 7490} New Operator Monitor Group Is Now Used on Certain D5R, D6K, D6N, D6T, D8R, and D8T Track-Type Tractors {1408, 7490}
986K Wheel Loader Systems Flood Lamp
Fuel Priming Pump on Certain C1.7 and C2.2 Engines {1258} Fuel Priming Pump on Certain C1.7 and C2.2 Engines {1258}
988K XE Wheel Loader Main Control Valve
C175-16 and C175-20 Locomotive Engines Control Cabinet - Assemble
D9R Track-Type Tractor Engine Supplement Air Cleaner - Remove and Install
C175-16 and C175-20 Locomotive Engines Control Cabinet - Disassemble
986K Wheel Loader Engine Supplement Fan Drive Motor - Remove and Install
330 and 330 GC Excavator Machine System Swing System
CG137-08 Engine Plate Locations and Film Locations
CG137-08 Engine Product Lifting
CG137-08 Engine Control Panel
C175-16 and C175-20 Locomotive Engines Turbocharger - Remove
CG137-08 Engine Sensors and Electrical Components
C175-16 and C175-20 Locomotive Engines Turbocharger - Install
C175-16 and C175-20 Locomotive Engines Exhaust Manifold - Remove and Install
CG137-8 Gas Engine Engine Control Switch - Test
New Final Drive Ring Gear Is Now Available for Field Installation on Certain Track-Type Tractors {4050} New Final Drive Ring Gear Is Now Available for Field Installation on Certain Track-Type Tractors {4050}
330 and 330 GC Excavator Machine System Travel System
CG137-08 Engine Engine Oil and Filter - Change