Fuel Transfer Pump - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new O-ring seal on the mounting flange of fuel transfer pump (3) .
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Show/hide table
Illustration 1 | g00618733 |
- Place fuel transfer pump (3) in position on the front housing and install the bolts that hold fuel transfer pump (3) in place.
- Connect tube assemblies (1), (2), and (4) .
- Turn ON the fuel supply to the engine.
Caterpillar Information System:
3608 Engine Fuel Priming Pump - Assemble
3608 Engine Fuel Priming Pump - Disassemble
C15 and C18 Petrolem Generator Set Engines Sensor Signal (Analog, Active) - Test
3608 Engine Fuel Injector - Install
3608 Engine Fuel Injector - Remove
3608 Engine Governor Drive - Assemble - Later
Specifications and Reusability for Hydraulic Gear Pumps and Motors (Groups 1, 2, and 3) {5061, 5073} Specifications and Reusability for Hydraulic Gear Pumps and Motors (Groups 1, 2, and 3) {5061, 5073}
3176C and 3196 Engines for Caterpillar Built Machines Belt Tensioner
3500B and 3500C Marine Propulsion Engines Engine Will Not Crank
3608 Engine Governor - Install
3608 Engine Governor - Remove
3608 Engine Crankcase Explosion Relief Valve - Remove and Install
3608 Engine Air Inlet Shutoff - Remove and Install
C15 and C18 Petrolem Generator Set Engines Sensor Signal (Analog, Passive) - Test
3608 Engine Exhaust Manifold - Remove and Install
Procedure to Update a Standard TH48-E80 Oil/Gas Transmission to a Warm-Up Mode TH48-E80 Oil/Gas Transmission{1408, 3083, 3160, 3168, 4800, 7610} Procedure to Update a Standard TH48-E80 Oil/Gas Transmission to a Warm-Up Mode TH48-E80 Oil/Gas Transmission{1408, 3083, 3160, 3168, 4800, 7610}
3608 Engine Turbocharger - Remove
3608 Engine Turbocharger - Disassemble
3608 Engine Turbocharger - Assemble
3608 Engine Turbocharger - Install
C175-16 and C175-20 Generator Set Engines Cylinder Head
14L Motor Grader Machine Systems Circle - Remove
3176C and 3196 Engines for Caterpillar Built Machines Engine Support (Front)
2007/12/24 An Improved Exhaust Bellow is Used {1059}