Piston Cooling Jet
Use compressed air in order to check the piston cooling jets for plugging.
Visually inspect the piston cooling jets for damage or distortion. If damage to a cooling jet is suspected, replace the piston cooling jet.
Note: The proper operation of the piston cooling jet is essential to ensure correct cooling and lubrication of the piston. When you remove the piston cooling jets from the engine, be sure to handle the cooling jets in a manner that the jets will not become damaged.
Show/hide table
Illustration 1 | g01337061 |
Side view of the piston cooling jet |
Show/hide table
Illustration 2 | g01337064 |
View A-A Piston cooling jet with a dual orifice |
(1) Diameter of the larger orifice for piston cooling jet ... 1.97 mm (0.078 inch)
(2) Diameter of the smaller orifice for piston cooling jet ... 1.37 mm (0.054 inch)
Caterpillar Information System:
C9 Petroleum Engines Diagnostic Flash Code Retrieval
Cleaning the Compression Brake{1129} Cleaning the Compression Brake{1129}
C9 Petroleum Engines Plate Locations and Film Locations
Air/Fuel Ratio Control View Screens (Display)
3512C Industrial Engine Front Drive Housing - Remove and Install
C15, C18 and C32 Marine Engine Service Meter Runs Constantly{1426, 4462} C15, C18 and C32 Marine Engine Service Meter Runs Constantly{1426, 4462}
Air/Fuel Ratio Control Reset to Start
0R-9393 Cylinder Pack Gp Piston Ring Position on Certain C16, 3406E, and 3456 Engines{1215, 1225} 0R-9393 Cylinder Pack Gp Piston Ring Position on Certain C16, 3406E, and 3456 Engines{1215, 1225}
584 and 584HD Forwarders Slope Operation
Air/Fuel Ratio Control Home Screen
Using the 9U-5383 Vacuum Tester {0774, 0781, 1000, 1100} Using the 9U-5383 Vacuum Tester {0774, 0781, 1000, 1100}
Air/Fuel Ratio Control Control Method
C7 Marine Engine Piston Cooling Jet
C7 Marine Engine Piston Cooling Jet
C7 Marine Engine Piston Cooling Jet
Inspection and Salvage of Rear Wheel Spindles for All Off-Highway Trucks {4201, 4205} Inspection and Salvage of Rear Wheel Spindles for All Off-Highway Trucks {4201, 4205}
CX28 On-Highway Transmission Transmission Charge Pump and Support - Install
3512C Industrial Engine Vibration Damper - Remove and Install
CX28 On-Highway Transmission Transmission Charge Pump and Support - Disassemble
CX28 On-Highway Transmission Transmission Charge Pump and Support - Assemble
Air/Fuel Ratio Control Control Target Setpoints
C3.3 Industrial Engine Water Pump - Inspect
C3.3 Industrial Engine Walk-Around Inspection
C3.3 Industrial Engine Turbocharger - Inspect - If Equipped