- An APC-1 board in the flywheel cabinet.
- A Flywheel Interface board (FWI) in the flywheel cabinet.
The flywheel should be in shutdown mode. The bus may purge down while performing this calibration. Load cell calibration is done for both Flywheel A and Flywheel B.
NOTICE |
---|
The flywheels should be at zero (0) RPM when performing this calibration. |
Perform the Flywheel A calibrations in the order that the calibrations appear on the Calibrate pull-down menu. Perform the following steps in order to calibrate the flywheel load cell.
- Place the keyswitch of the Flywheel cabinet in the "Spindown/Offline" position.
- Connect a PC to the UPS according to the instructions in Testing and Adjusting, "Personal Computer to UPS Connection".
- Place the system in the Bypass mode. Refer to Testing and Adjusting, "Transfer to Bypass Mode".
- Open the "Calibrate" drop-down menu in UPS View.
Illustration 1 | g01321408 |
Calibrate Load Cell |
- Select "Load Cell" from the "Calibrate" drop-down menu.
The window which is shown in illustration 2 appears.
- Click the "Use Defaults" button.
Illustration 2 | g01321410 |
A: Load Cell - Minimum Bottom Bearing Force |
- Disconnect the wiring harness from "J4" of the interface board connector for Flywheel A.
- Plug the "MIN" jumper connector (3) into "J4" of the interface board connector for Flywheel A.
Illustration 3 | g01321411 |
Flywheel Interface Board With a Jumper in J4 (1) MIN/MAX Jumper |
- Ensure that the "Minimum" button is highlighted in the "Calibration of a Channel" window.
The value for the minimum setting should be close to zero (0).
Illustration 4 | g01321439 |
View of "Min/Max Jumpers" for new FWI PWAS (2) 268-0058 Cable Assembly (MAX) (3) 268-0057 Cable Assembly (MIN) |
- Click the "OK" button.
- Click the "Maximum" button.
Illustration 5 | g01321414 |
A: Load Cell - Maximum Bottom Bearing Force |
- Change the jumper in J4 from the "MIN" jumper (3) to the "MAX" jumper (2).
The load cell reading should be approximately 1333 lb.
- Click the "OK" button.
- Click the "View Status" button.
- Remove the jumper and reconnect the harness.
Illustration 6 | g01321416 |
Bottom Bearing Force Calibration Status |
- Click the "Save" button.
- Repeat for Flywheel B.