Rocker Shaft - Disassemble
Disassembly Procedure
Start By:
- Remove the rocker shaft and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Slide rocker shaft (7) from the end of base (9) .
Show/hide table
Illustration 1 | g00842949 |
Show/hide table
Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force. |
- Remove rocker arms (1), rocker arms (2), washers (3), and springs (4) .
Note: Place an identification mark on each of the components for installation.
- Remove adjusting screws (6) and nuts (5) from rocker arms (1) and rocker arms (2) .
- Inspect all of the components from base (9) for wear or damage. If any of the components are worn or damaged, use new parts for replacement.
- Inspect O-ring seal (8) for wear or for damage. If the O-ring seal is worn or damaged, use a new part for replacement.
Caterpillar Information System:
C15 Generator Set Engines Sensors and Electrical Connectors
3600 Distillate Fuel Engines Product Storage
2005/09/12 Improved Seal on Fuel Filter {1261}
2005/09/01 Improved Seal on Fuel Filter {1261}
C15 Petroleum Generator Set Engines Vibration Damper - Check
C175 Generator Set Engines Water Pump - Install
C1.5 and C2.2 Generator Set Engines Rocker Shaft and Pushrod - Remove
2007/07/30 Improved Seal on Fuel Filter {1261}
C175-16 and C175-20 Locomotive Engines Water Pump - Remove
C15 Petroleum Generator Set Engines Fuel System - Prime
C15 Petroleum Generator Set Engines Cooling System
C15 Petroleum Generator Set Engines Air Inlet and Exhaust System
C1.5 and C2.2 Generator Set Engines Rocker Shaft - Assemble
C1.5 and C2.2 Generator Set Engines Rocker Shaft and Pushrod - Install
C175 Generator Set Engines Engine Oil Screen - Remove and Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Sprocket - Remove and Install
C1.5 and C2.2 Generator Set Engines Cylinder Head - Remove
C15 and C18 Industrial Engines Engine Oil Pan
C32 Petroleum Engines Engine Oil Cooler - Install
2005/09/12 Make Sure to Clean the Shaft for the Engine Oil Scavenge Pump's Gear {1312}
C15 Generator Set Engines Engine Temperature Sensor Open or Short Circuit - Test
2005/09/12 Remanufactured Rocker Arm has been Changed {1123}
C1.5 and C2.2 Generator Set Engines Cylinder Head - Install
C13, C15, and C18 Tier 4 Final Engines Engine Oil Pan