CB 1 Set Limits Fault
Conditions Which Generate This Code:
Show/hide table
Illustration 1 | g01026517 |
This diagnostic code is associated with the calibration of the lift valve and the tilt valve. The blade has moved outside of the upper or lower limits that have been previously set for the calibration.
System Response:
When this diagnostic code is active, "EXIT ERROR" will be shown on the display LCD.
Test Step 1. RECALIBRATE THE VALVE
- Restart the valve calibration procedure. Refer to Systems Operation, Troubleshooting, & Testing and Adjusting, "Bank valve (Grade Control) - Calibrate"
Expected Result:
Recalibration causes the diagnostic code to become inactive.
Results:
- OK - Calibration causes the diagnostic code to become inactive.
Repair: Return the machine to normal operation.
Stop.
- NOT OK - Calibration has not caused the diagnostic code to become inactive.
Repair: The calibration was not performed correctly. Perform the calibration again. Refer to Systems Operation, Troubleshooting, & Testing and Adjusting, "Bank valve (Grade Control) - Calibrate".
Stop.
Caterpillar Information System:
SCJ and 8SC Series Alternators Regulator - Test
992G Wheel Loader Electrohydraulic System Lift and Tilt Cylinder Drift (VIMS) - Check
SCJ and 8SC Series Alternators Diode Assembly - Test
C15 and C18 Engines for Caterpillar Built Machines Vibration Damper - Check
992G Wheel Loader Electrohydraulic System Electrical System Schematic
525B and 535B Wheel Skidders Machine Systems Hydraulic Rotator - Install - Standard Rotation Grapple
525B and 535B Wheel Skidders Machine Systems Hydraulic Rotator - Remove - Standard Rotation Grapple
2004/05/17 Special Instruction, REHS2154, "Procedure To Replace The Enclosure Brackets On A 973C Track-Type Loader" is Now Available {7263}
C175-16 Locomotive Engine Cooling System Coolant Extender (ELC) - Add
906 and 908 Wheel Loaders Hydraulic and Steering System Pilot Hydraulic System
D10T Track-Type Tractor Power Train Torque Divider
3408E and 3412E Engines for Caterpillar Built Machines Vibration Damper
992K Wheel Loader and 854K Wheel Dozer Braking System Pressure Sensor (Service Brake Oil)
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarriers Machine Systems Cab - Remove
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarriers Machine Systems Cab - Install
SCJ and 8SC Series Alternators Residual Magnetism - Restore
SCJ and 8SC Series Alternators Brush Assembly - Test
SCJ and 8SC Series Alternators Brush Length - Check
C11 and C13 Engines Cylinder Head Valves
D10T Track-Type Tractor Indicators and Gauges - Test
AccuGrade Laser System CB 2 Lost Beam
AccuGrade Laser System CB 3 Calibration Failure
D3G, D4G and D5G Track-Type Tractors AccuGrade Laser CB 6 Wrong Blade Motion
AccuGrade Laser System CB 8 No Blade Movement