Display Position Adjustment
Do not position the display in order to cover any warning stickers or other important information.
Do not position the display in order to impede the entry to the machine cab or exit from the machine cab.
Do not position the display in order to obstruct the operator's outside view.
Do not position the display in order to obstruct the operator's view of machine instrumentation.
Do not position the display in order to impair access to operator controls or movement of operator controls.
Show/hide table
Illustration 1 | g01367987 |
Mounting Clamp Assembly (1) Clamp (2) Clamp Handle |
Show/hide table
Illustration 2 | g01368064 |
(3) Ball Mount Base |
Show/hide table
Illustration 3 | g01367988 |
Installation of the Display and Mounting Assembly (3) Base for the Ball Mount (4) Display (5) Mounting Clamps (6) Dumbbell (7) Mounting Clamp Handles |
Refer to Illustration 3. In order to position the display (4), hold the display (4) securely. Loosen the mounting clamp handle or handles (7) on the mounting clamps (5) for the display . Adjust the display (4). Tighten the handle or handles (7) on the mounting clamps (5) for the display (4) after the display (4) is positioned.
Show/hide table
Illustration 4 | g01368029 |
Example of an Installation on a Wheel Loader (3) Base for the Ball Mount (4) Display (5) Mounting Clamp (8) Mounting Bracket for the Display (9) Mounting Bolt for the Ball Mount |
Show/hide table
Illustration 5 | g01368041 |
Example of an Installation on a Wheel Loader (10) Installed WAVS |
Caterpillar Information System:
C4.4 and C6.6 Engines for Caterpillar Built Machines Injector Solenoid Circuit - Test
C15 On-Highway Engine Basic Engine
Work Area Vision System General Information
Work Area Vision System Camera - Clean
Work Area Vision System Display - Clean
C6.6 Industrial Engine Engine Oil Pan
Work Area Vision System Modes Of Operation
Work Area Vision System Safety
C32 Marine and Auxiliary Marine Engines Auxiliary Water Pump - Remove
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Analog Throttle Position Sensor Circuit - Test
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Indicator Lamp Circuit - Test
C15 On-Highway Engine Engine Oil Pressure - Test
Work Area Vision System Display Picture Adjustment - Select Display Settings
Work Area Vision System Display Description
Work Area Vision System Camera Description
C15 Generator Sets Safety Messages
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Engine Pressure Sensor Open or Short Circuit - Test
2008/07/21 New Inlet Valve Guide Seal and New Cylinder Head Groups {1104, 1225}
C15 On-Highway Engine Electronic Unit Injector - Test
C32 Marine Engines Auxiliary Water Pump - Disassemble
3126B Generator Set Engine Sensors and Electrical Connectors
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Refrigerant Receiver-Dryer - Remove and Install
C32 Marine Engines Auxiliary Water Pump - Assemble
C13 and C15 On-highway Engines Diagnostic Trouble Codes