Product Lifting
Show/hide table
插圖 1 | g00103219 |
Show/hide table
注意事項 |
---|
切不可將吊環螺栓和托架弄彎。 只可在張力下給予吊環螺栓和托架負載。 請記住,若支撐件和物體之間的角度變得小於90度,吊環螺栓的能力會由此變小。 當需要把某個角度上的組件拆下時,只可使用與其重量成比例的連接支架。 |
用起重機來拆卸重的組件。 用可調整起重樑來吊舉引擎。 所有的支撐件 (鏈條和鋼索) 都必須相互平行。 鏈條和鋼索應該垂直於被吊舉物體的頂部。
有些拆卸工作要求用吊舉設備,以取得較佳的平衡。 吊舉設備也可提供安全性能。
若只拆卸引擎,請使用該引擎上的吊環。
吊環是針對特殊引擎配置所設計和安裝的。 若更改吊環和/或引擎,則吊環和吊舉設備可能不適用。 如果已經更改這些物件,則必須保證可以提供適當的吊舉裝置。 如需適當提升引擎的裝置資訊,請向您的 卡特彼勒代理商諮詢。
Show/hide table
注意事項 |
---|
不要使用引擎上的吊環螺栓移動引擎和發電機。 |
同時吊舉引擎和發電機需要特殊設備和程序。 若需適當吊舉您引擎密封裝置資訊,請洽詢您的 卡特彼勒代理商。
如果您用單點吊環來吊舉發電機組包裝箱時,它將無法保持水平。 只要應用場合需要經常重新定位組件,就可能要在包裝機架軌樑之間加一個平衡配重。 如需關於加平衡配重的完整資訊,請諮詢您的 卡特彼勒代理商。
單點吊環在封裝出廠前已由原廠緊固。 若單點吊環的定位正去,當您站在外殼的一側時,就能看穿其環孔。 當吊舉機件時,吊環可能會撐大。 這可能會導致鎖緊螺帽鬆開。 使吊環可以旋轉。 請確認吊環在已包裝的發電機組上處於正確的方位。 在吊舉已包裝的發電機組之前,要確認已用正確的扭力鎖緊吊環。
吊舉配備燃油箱的引擎需要特殊的設備和程序。 油箱裏有燃油時不要吊舉。 如需適當吊舉您的整體設備的資訊,請向您的 卡特彼勒代理商諮詢。
Caterpillar Information System:
G3408 and G3412 Engines Camshaft Bearing Position
UPS 250 and UPS 300 Uninterruptible Power Supplies System Description
G3408 and G3412 Engines Governor Control
C15 On-highway Engine Compression Brake - If Equipped
G3606 and G3608 Engines Refill Capacities and Recommendations
G3500B Engines Air/Fuel Ratio Control - Adjust - Oxygen Feedback - Generator Set Application
3456 Generator Sets Refill Capacities and Recommendations
C15 Petroleum Generator Set Engines Cooling System - Inspect
C15 Petroleum Generator Set Engines Aftercooler - Test
G3500B Engines Exhaust Bypass Valve - Adjust
Installation Guide for Product Link PL121SR and PL321{7606} Installation Guide for Product Link PL121SR and PL321{7606}
2004/08/01 New Gasket for the Turbocharger Oil Line {1052, 1307}
349F and 352F Excavators Engine Oil Sample - Obtain
C13, C15, and C18 Generator Set Engines Cooling System
Quick Coupler (Dedicated Wedge Lock) Quick Coupler - Clean/Inspect
345C MHPU Mobile Hydraulic Power Unit Engine Crankcase Breather - Clean
G3408 and G3412 Engines Camshaft Bearing Position
G3406 Engines Camshaft Bearing Position
C15 On-highway Engines Sensors and Electrical Connectors
2004/08/16 Instructions for Filling the Oil of Nexus and Classic Carrier Roller and Idler {4154, 4159}
C15 On-highway Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
G3408 and G3412 Engines Cylinder Head
C13 and C15 Engines for Combat and Tactical Vehicles Engine Coolant Diverter Circuit - Test
G3606 and G3608 Engines Cooling System Coolant (NGEC) - Change