Water Pump - Remove
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Drain the coolant system. Refer to Operation and Maintenance Manual, "Refill Capacities and Recommendations".
Show/hide table
Illustration 1 g01090033 - Remove cover guard (1).
Show/hide table
Illustration 2 g01090034 - Disconnect tube assembly (2).
Show/hide table
Illustration 3 g01090036 - Loosen clip (3) and disconnect tube assembly (4).
Show/hide table
Illustration 4 g01090039 - Disconnect tube assembly (2) and tube assembly (4). Reposition tube assembly (2) and tube assembly (4) out of the way.
- Loosen clamps (7).
- Remove bolts (5) and cover (8). Remove tube assembly (2), tube assembly (4), and hoses (6).
Show/hide table
Illustration 5 g01090056 - Remove bolts (10), nuts (9), and bolt (11).
- Remove water pump (12).
Caterpillar Information System:
G3520B Industrial Engine Ignition Transformers Primary Circuit
C15 and C18 Tier 4 Final Engines Inlet Manifold Pressure - Test
G3300 Engines After Stopping Engine
C9 Marine Generator Set Engines Gear Group (Front) - Time
2008/10/06 New Tubes for Plate Type Heat Exchangers that Are Designed To Order (DTO) {1379}
G3520B Industrial Engine Fuel Metering Valve
3500B High Displacement Generator Set Engines Product Storage
C6.6 Marine Generator Set Generator Installation
3500B Locomotive Engines Cylinder Head Valves
TK711, TK721, TK722 and TK732 Track Feller Bunchers Seat
G3520B Industrial Engine Engine Speed/Timing Sensor
C27 and C32 Engines Piston Ring Groove - Inspect
EMCP3 Wiring Harness (Open Circuit) - Test
EMCP3 Wiring Harness (Short Circuit) - Test
EMCP3 Electronic Control Module (Generator Set) - Flash Program
G3500B Engines Throttle Control Valve - Check
EMCP3 ECM Connections
2004/07/01 A New Housing for the Speed/Timing Sensor and a New Speed/Timing Sensor are Used {1210, 1907}
3412E, C30 and C32 Marine Engines Water Pump - Install
G3520B Industrial Engine Integrated Temperature Sensing Module (ITSM)
2004/08/01 Special Instructions Are No Longer Announced In the Truck Engine News {1000}
2004/08/01 Special Instructions Are No Longer Announced In the Engine News {1000}
2004/10/01 Reduced Oil Change Intervals {7542}
3126E Truck Engines Maintenance Interval Schedule - Engines with a Shallow Oil Sump