Auxiliary Water Pump - Install
安装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
注意 |
---|
由于端面密封损坏,水泵可能会发生泄漏。 轴和壳体之间的相对移动可能会使传动轴接触到水泵上的端面密封。 如果发生接触,将损坏端面密封并导致过早发生故障。 |
注: 千万不要用轴提升辅助水泵。 将辅助水泵安装到发动机上时千万不要碰撞到轴。
- 将附件驱动轴 (13) 滑动到辅助水泵 (8) 的轴上。 将止推垫圈 (15) 置于辅助水泵上,然后安装螺栓 (14) 。
Show/hide table
图 1 | g01009132 |
- 将附件驱动齿轮 (12) 置于附件驱动轴 (13) 上。 安装螺栓 (11) 。
Show/hide table
图 2 | g01009118 |
- 辅助水泵 (8) 、附件驱动轴以及附件驱动齿轮的重量约为48 kg (106 lb)。 用一个合适的举升设备将部件安装到前驱动壳体中。 安装螺栓 (7) 。
Show/hide table
图 3 | g01009100 |
- 恒温控制阀总成 (9) 的重量约为 28 kg (62 lb)。 用一个合适的举升设备定位恒温控制阀组件 (9) 。 安装螺栓 (3) 。 安装螺栓 (6) 以将恒温控制阀组件 (9) 紧固到支架 (10) 上。
- 将 O 形密封圈安装在管 (1) 上,然后将管 (1) 安装到辅助水泵 (8) 上弯头上。 安装挡圈 (2) 、座圈和螺栓以固定管 (1) 。
- 将 O 形密封圈安装到管 (5) 上,然后将管 (5) 安装到恒温器控制阀组件 (9) 中。 安装挡圈 (4) 、座圈和螺栓以固定管 (5) 。
Caterpillar Information System:
Cat® Digital Voltage Regulator Remote Communication
C11, C13 and C15 On-highway Engines Input Selections
C11, C13 and C15 On-highway Engines Vehicle Speed Parameters
C11, C13 and C15 On-highway Engines Dedicated PTO Parameters
C11, C13 and C15 On-highway Engines Engine Monitoring Parameters
C11, C13 and C15 On-highway Engines Idle Parameters
C11, C13 and C15 On-highway Engines Engine/Gear Parameters
C3.3 Industrial Engine Fuel Injector - Install
3406C Marine Auxiliary Generator Set Gauges and Indicators
G3500 Engines Duplex Oil Filter - Adjust
2003/08/01 New Fabricated Tool for Piston Pin Installation {1225}
C15 On-highway Engine Gear Group (Front) - Install
2003/07/01 Replacement of the ECM for Heavy-Duty On-Highway Engines {1901}
2003/10/01 Policy for Reusing the Turbocharger Turbine Housing {1052, 1065, 7754}
2003/07/01 Identifying the Prelube Circuit and the Air Start Circuit {1408}
120H and 135H Motor Graders Machine Systems Metering Pump (Steering) - Remove and Install
3512C HD SR500 Generator Sets Single Unit Operation
C15 and C18 Petroleum Generator Sets Parallel Operation
C7 On-highway Engine Turbocharger - Remove
C7 Engines for Combat and Tactical Vehicles Engine Oil Level Gauge - Calibrate
C7 On-highway Engine Turbocharger - Install
C7 On-highway Engine Cylinder Head - Remove
C7 On-highway Engine Cylinder Head - Install
C7 On-highway Engine Electronic Control Module - Remove and Install