Rocker Shaft - Disassemble
Disassembly Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 1P-1855     | Retaining Ring Pliers     | 1     |
Start By:
- Remove the rocker shaft and pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Remove".
- Use Tooling (A) to remove retaining rings (5) .
Show/hide table
Illustration 1 | g01035060 |
Show/hide table
Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force. |
- Place an identification mark on each of the components for installation purposes.
- Remove rocker arm assembly (4) .
- Remove bracket (3) .
- Remove rocker arm assembly (2) .
- Remove spring (1) .
- Repeat Steps 3 through 6 in order to completely disassemble the rocker shaft assembly.
Caterpillar Information System:
2003/06/01 Guidelines for Modifying the Cylinder Head and the Prechamber Assembly for 1/2 Inch Bolts {1101}
3044C Industrial Engine and Engines for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove
3044C Industrial Engine and Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
G3304 and G3306 Engines Valve Guides - Remove and Install
3500B and 3500C Marine Propulsion Engines MID 036 - CID 0268 - FMI 02 Check Programmable Parameters
2003/06/01 Service Literature is Now Available {0375, 7568}
G3500 Engines MID 014 - CID 0329 - FMI 11 Communication Fault with CAT A/F Ratio Control
G3500 Engines MID 014 - CID 0328 - FMI 02 Number of Cylinders mismatch
2003/06/01 A New Personality Module is Available for G3600 Engines {1902, 7620}
G3500 Engines MID 014 - CID 0327 - FMI 02 Number of Detonation Sensors mismatch
G3500 Engines MID 014 - CID 0326 - FMI 01 Detonation Retarded Timing
C9 Marine Engines Safety Messages
3500B Series II Marine Engines MID 036 - CID 0799 - FMI 12 Need Service tool update
3500B Series II Marine Engines Event Codes
3044C Industrial Engine and Engines for Caterpillar Built Machines Rocker Shaft - Assemble
3044C Industrial Engine and Engines for Caterpillar Built Machines Rocker Shaft and Pushrod - Install
C-10, C-12, C-15 and C-16 Industrial Engines E004 Engine Overspeed Shutdown
G3304 and G3306 Engines Valve Seat Inserts - Remove and Install
3500B Series II Marine Engines E039 Low Engine Oil Pressure Derate
3044C Industrial Engine and Engines for Caterpillar Built Machines Cylinder Head - Remove
PM820, PM822, and PM825 Cold Planer Engine Valve Lash - Check
3044C Industrial Engine and Engines for Caterpillar Built Machines Cylinder Head - Install
3500B Series II Marine Engines Air Shutoff System
G3304 and G3306 Engines Water Directors - Remove and Install