Crankshaft Front Seal - Remove
拆卸步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件说明     | 数量     |
A     | 1U-7600     | 滑锤拉拔器     | 1     |
B     | 1U-8145     | 钻头     | 1     |
开始:
- 拆下减振器和皮带轮。 请参阅拆解和组装, "减振器和皮带轮 - 拆卸和安装"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 使用工具 (B) ,在曲轴前油封 (1) 上小心钻出三个等距的孔。
Show/hide table
图 1 | g00989224 |
- 使用工具 (A) 拆下曲轴前油封 (1) 。
Caterpillar Information System:
C7 On-Highway Engine Vibration Damper and Pulley - Remove and Install
G3304 and G3306 Engines Timing Gears - Install
C15 On-Highway Engines Electronic Unit Injector - Adjust
3516B and 3516B HD Engines and 994D, 994F, and 994H Wheel Loaders Camshaft
G3500B Engines Start/Stop Control
G3304 and G3306 Engines Timing Gears - Remove
C7 On-Highway Engine Crankshaft Rear Seal - Remove
3044C Industrial Engine Cooling System Supplemental Coolant Additive (SCA) - Test/Add
G3304 and G3306 Engines Timing Gear Cover - Remove and Install
C7 On-highway Engine Air Inlet Cover - Remove and Install
G3500B Engines Electronic Control System Operation
G3500C and G3500E Generator Set Engines Compressor Bypass - Adjust
3054E Industrial Engine Housing (Front) - Install
C7 Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
C7 On-Highway Engine Speed/Timing Sensor - Remove and Install
G3304 and G3306 Engines Timing Gear Plate - Remove and Install
C7 On-Highway Engine Boost Pressure Sensor - Remove and Install
C7 and C9 On-Highway Engines Intermittent Low Power or Power Cutout
C7 On-Highway Engine Inlet Air Temperature Sensor - Remove and Install
G3500B Engines Engine Governing
C7 On-Highway Engine Housing (Front) - Remove
C7 On-Highway Engine Unit Injector Hydraulic Pump - Install
C7 On-Highway Engine Housing (Front) - Install
G3304 and G3306 Engines Engine Oil Pan - Remove