Water Pump - Test
Show/hide table
Engine surfaces and fluids can be hot. A running engine will have moving belts exposed at the front of the engine (rear of bus). These hazards can result in personal injury or death. stop the engine while connecting test equipment and work carefully around a running engine. Do not allow tools or test equipment to protrude or vibrate into the path of rotating belts. |
Show/hide table
Required Tools     | ||
Part Number     | Part Name     | Quantity     |
6V-7775     | Air Pressure Gauge     | 1     |
Show/hide table
Illustration 1 | g00945097 |
(1) Port |
Perform the following procedure in order to determine if the water pump is operating correctly:
- Remove the plug from port (1).
- Install the 6V-7775 Air Pressure Gauge in port (1) .
- Start the engine. Run the engine until the coolant is at operating temperature.
- Note the water pump pressure. The water pump pressure should be 100 to 125 kPa (15 to 18 psi).
Caterpillar Information System:
C9 Urban Transit Bus Engine Cooling System - Test
G3500B Engines Power Supply
3126B Truck Engine Maintenance Interval Schedule - Engines With a Deep Oil Sump
3126B Truck Engine Maintenance Interval Schedule - Engines With a Shallow Oil Sump
3126B Truck Engine Safety Messages
C9 Urban Transit Bus Engine Noise from Injectors with Key Switch ON
3054C Industrial Engine Aftercooler Core - Clean/Test
C7 and C9 On-Highway Engines Engine/Gear Parameters
2003/02/01 Correction to Troubleshooting, RENR5910-01 , "Engine Speed/Timing Sensor" {1907, 1912}
2003/02/01 Correction to Systems Operation/Testing and Adjusting, RENR5908-01 , "Procedure for Engine Timing" {1000, 1900}
2003/01/01 227-4236 Electrical Cable is Available {4459}
2002/12/01 A New Service Manual, RENR2495, "3600 Engines PanelView Monitor" is Available {0374}
3056E Industrial Engine Connecting Rod Bearings - Remove
3056E Industrial Engine Connecting Rod Bearings - Install
3406E, C12, C15 and C18 Marine Engines Engine Pressure Sensor Open or Short Circuit - Test
3056E Industrial Engine Pistons and Connecting Rods - Remove
3056E Industrial Engine Pistons and Connecting Rods - Disassemble
3056E Industrial Engine Pistons and Connecting Rods - Assemble
3056E Industrial Engine Pistons and Connecting Rods - Install
3126B Marine Engines Transmission Oil Temperature Sensor Open or Short Circuit - Test
2002/12/01 A New Top Piston Ring Promotes Reduced Cylinder Liner Wear {1214, 1215}
3126E Truck Engine Electrical System
C4.4 (Mech) Industrial Engine Electric Starting System - Test
G3500 Engines Vibration Damper Guard